ADC Telecommunications Inc. DVLRCSSMR Benutzerhandbuch
ADCP-75-134 • Issue A • April 2002 • Section 4: Operation
Page 4-9
©
2002, ADC Telecommunications, Inc.
8. Select
an attenuator that is as close to the value calculated in step 7 as possible. Select a
value
that will adjust the signal level of the composite input signal to fall within the
specified
range.
9. Install
the external attenuator in the coaxial cable that is connected to the FORWARD RF
IN
port at the HU.
10. Subtract
the value of the external attenuator used in step 9 from the total composite signal
power
(P
tot
)
and record the result. This value will be required when setting the attenuation
of
the HU’s internal forward attenuator.
2.4
Enter Site Number and Site Name
All
HU’s and RU’s are programmed with the same site number and site name. It is therefore
necessary
to assign a unique site name and site number to the HU and RU before they can be
connected
to the same CAN. Use the following procedure to assign a unique site number and
name
to each HU and RU system:
1. Click
on the HOST Config tab and on the REMOTE Config tab. The HOST Config
display
and the REMOTE Config display will open within the EMS main window as
shown
Figure 4-6. HOST and REMOTE Config Displays
2. Right-click
on the HOST Site Number (see
The Site Number pop-up screen
will
open as shown in Figure 4-4. Enter any odd number between 33 and 61 and then click
on
OK to close the screen and make the changes take effect.
HOST Site Number
HOST Site Name
REMOTE Site Number
(Entered automatically
when the HOST site
number is selected)
(Entered automatically
when the HOST site
number is selected)
REMOTE Site Name
Right-Click on the
point shown to open
pop-up screen
point shown to open
pop-up screen
FCC ID: F8I-DVLRCSSMR Class II Permissive Change
Manual - Part 5