ADC Telecommunications Inc. PSM25TDH Benutzerhandbuch
FWPP-501-01 Issue 1
•
320000117795 Rev A
FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc.
Page 61
Install the Prism Remote Unit
Option B: Fiber Pass-Through Connector
NOTE:
Use the following procedure to install the fiber cables using a Fiber Pass-Through Connector.
• If the PRU that you are installing has a Hardened Multi-Fiber Optic Connector, follow the
• If the PRU that you are installing has a legacy ProAx Connector, follow the procedure in
NOTE:
The graphic shown in this procedure depict an AC-powered PRU. However, the Fiber 1 and
Fiber 2 connectors on a DC-powered PRU are in the same location and use the same procedure
as the AC-powered PRU to install fiber cables using a Fiber Pass-Through Connector.
Fiber 2 connectors on a DC-powered PRU are in the same location and use the same procedure
as the AC-powered PRU to install fiber cables using a Fiber Pass-Through Connector.
Use the following procedure to install the fiber cables using the ProAx connector:
1
1
Obtain an environmentally hardened fiber cable terminated with LC connectors. The outside
diameter of the cable jacket must be between .
and .
.
2
3
Remove connector plug only from the Fiber connector, unless multiple fiber cables are needed.
NOTE:
Do not remove the dust cover from the Fiber 2 connector until directed to do so.
Connector
plugs