Schlumberger Sema 26-0288 Benutzerhandbuch
Installation Manual, BLT Transceiver
04/ 11/ 02
Page 1 of 3
INSTALLATION OF THE BLT TRANSCEIVER
MODEL NUMBER: 26-0288 & 26-0166
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
WARNING
In order to comply with FCC RF Exposure requirements, this device
must be installed in such a way as to ensure that a minimum separation
distance of 20 cm is always maintained between the antenna and all persons.
distance of 20 cm is always maintained between the antenna and all persons.
Installers and end-users must follow the installation instructions
provided in this guide.
The module is not modified
The module is only used or configured with antennas provided. Do
not use other antennas that have not been approved or tested. Doing so will
violate the grant of authorization approval and could result in a system
exceeding the RF Exposure Requirements or the FCC radiation limits.
violate the grant of authorization approval and could result in a system
exceeding the RF Exposure Requirements or the FCC radiation limits.
The module is properly label and if being installed inside a product,
were the Module’s FCC ID is not visible, then an external label must be
place on the outside of the device, stating the following:
place on the outside of the device, stating the following:
“Contains Transmitter Module FCC ID: F9C26-0288”
The FCC warning statements and compliance statements found in this
The FCC warning statements and compliance statements found in this
installation manual for the module must be replicated in the manual for the
host equipment, specifically those related to RF exposure.
host equipment, specifically those related to RF exposure.
The module is approved only as a mobile device. The final
configuration, where the module will be installed, must meet the 20-cm
requirement for it to be classified as mobile. The final configuration must,
also, be in compliance with the RF exposure requirements. The module is
not approved for portable applications. If portable application is desired,
then a separate FCC equipment authorization is required.
requirement for it to be classified as mobile. The final configuration must,
also, be in compliance with the RF exposure requirements. The module is
not approved for portable applications. If portable application is desired,
then a separate FCC equipment authorization is required.