Lg Electronics LST200 Benutzerhandbuch

13

1.  The POWER LED indicates the presents status;

1) Using AC Adapter : Solid Green
2) Using internal battery : Solid Yellow

2.  If the radio service is not available or radio signal is too weak to detect;

The SIGNAL LED is Red. (No Service status)

3. When the phone is succeeded in getting the service, SIGNAL LED indicates the strength

of the signal.

1) Lifting handset, dial tone is heard and you can enter a phone number.

  (Not entering any key for 15 seconds, warning tone will be produced)

*) If Hot Line function is enabled, busy tone is not produced and hot line number is
  automatically connected.
*) While having maintenance order from the main system, neither dial tone nor busy

tone is produced.

When lifting handset of the connected phone ("off hook"), the terminal determines whether
cellular service is available. If it is available, dial tone is produced and a number can be dialed
normally. If phone service is not available, LED 2 of the terminal (Signal LED) will be red and
no dial tone will be heard.

The connected telephone rings when an incoming call is detected. Pick up the handset and
begin talking.

When you have completed the call, place the handset back on hook. Also you can hook flash
more than 1 second to end a call and place a new call without hanging up the handset.

A warning tone may be heard in the telephone after a remote party hangs up from a call,
allowing another call to be initiated after hookflash. To transmit the dialed digits immediately,
press “#” key after dialing the phone number.

The terminal waits 5 seconds (user programmable feature) before transmitting the dialed
telephone number into the cellular network. If you want transmit dialed telephone number
immediately, then press “#”  after dialing digits.