KYE Systems Corp GKZGL Benutzerhandbuch

1. 

You can connect the receiver to a USB port of a PC.

2. 

Install two AA rechargeable batteries in the mouse and two AA rechargeable batteries in the keyboard.

3. 

Turn on your computer.

4. 

After you open Windows, please press the button 

on

 the receiver first (RB) and then press the button under the mouse (MB)

and keyboard (KB) for ID channel setting. You only have six seconds to press the receiver, the channel button on the keyboard

(KB), then the receiver button again and the channel button on the mouse (MB). So you press RB, KB, RB, MB to set the

channel setting.

Important: You can use the battery charger receiver to recharge two AA or two AAA rechargeable batteries each time when you use

the PC. Plug the battery charger receiver USB connector into the PC directly and remember do not put the batteries in the wrong

direction, use the same types of batteries, and if you recharge via the USB hub, that will make your receiver, main-board and hub

burn or become non-usable easily. Also, keep all drinks away! If any spill occurs on the receiver, unplug the USB connector first

and clean the receiver immediately. Please remove the batteries if you do not use this device for at least two weeks.

1. 

When you use Wireless TwinTouch Optical Office on a desk that is made of metal, try using a pad and reduce the receiving

distance.

2. 

Before the first installation is completed (channel setting ready), the keyboard and mouse will not work in DOS. If your USB

3. 

The Wireless TwinTouch Optical Office channel provides 256 ID-codes, and it automatically selects the ID # for your

keyboard and mouse. You can only set up one Wireless TwinTouch Optical Office at a time. But if you have additional

Wireless TwinTouch Optical Office sets in an area of 10 square meters, more interference will occur between the receiver and

your keyboard and mouse.

4. 

If you feel the mouse does not move smooth as usual or the keyboard does not work when typing, that the batteries have lost

their charge, so please replace them. Also, the wireless icon will be blinking “red” when there is a battery-low situation. The

LED on the receiver shows the battery-recharging status (from shining to LED completely “on” for battery full). 

                   

    

5. 

If you need to buy new batteries, please choose Ni-MH (Nickel-Metal-Hydride) batteries with AA size, 1300 to 1600 mAH

and 1.2 Voltages. Please do not mix or use other types of batteries (Li-ion, Ni-Cd, Alkaline, etc.).

6. 

The Wireless TwinTouch Optical Office with radio frequency gives you free movement and an enjoyable experience. For

optimal performance, place the receiver at least 8 inches (about 20 cm) away from the mouse and other electrical devices,

such as the computer, monitor, and etc.