KYE Systems Corp GKZHA Benutzerhandbuch

1.  Place two AA batteries in the keyboard as shown below. 
2.  Connect the dongle receiver to a USB port of a PC. 

3.  Turn on your computer. 
 
 

 
 
 

 
 
 

 

 

 

 

 

No software is required to start up the wireless device. 
 
 

If you feel that the wireless device does not respond when typing, check if the red LED is flashing when any key is 
pressed. If not, this means that the batteries have lost their charge and need to be replaced. 

 
 
 

 
 
 

 
 
 

 
 
 

 
Important: Do not mix or use different types of batteries at the same time. 

The channel ID is factory preset. The green LED (data transmission indicator of the receiver) will be lit constantly 
when the wireless device is in normal operation. In case your wireless devices do not work, reset the ID channel 
by: 

1.  Press the connect button on the receiver and the LED will be blinking for connection.   
2.  Press the connect button of the wireless device once within 20 seconds and observe if the LED light on the 

receiver has gone off. If yes, it means the wireless device is ready for use. 

 

1.  In case the wireless device was not connected when you set the ID channel setting, check if you have installed 

the batteries with the positive (+) and negative (-) ends in the correct position, then repeat the ID channel 
setting again. 

 

2.  For optimum performance, please make sure that the distance between the wireless device and the dongle 

receiver does not exceed 10M. 

 

Data transmission 
indicator 

Connect button