Everspring Industry Co Ltd SE813 Benutzerhandbuch

 
SE813 is a battery operated alarm siren with audio playback capability and built-in temperature/humidity 
sensor. 
 
Main features: 
 

 

Piezoelectric siren emits alarm sound when activated under emergency. 

 

 

Playback of prerecorded audio sound from built in speaker. User can download sound files from 
PC into the unit’s memory and played back through commands sent from Z-wave controller. 

 

 

Built in digital temperature and humidity sensor reports environmental condition to the controller. 
 

 

Z-Wave Plus certified device and can connect up to 5 Z-Wave controllers simultaneously. 
 

 

Supports Z-wave S2 security protocol. A security-enabled Z-Wave Controller must be used to 
utilize this security feature. 
 

 

Tamper switch to detect removal of its cover. 

 
 
This product is ideal for smarthome scenarios using voice notification or voice alerts, adding a more user 
friendly interaction with the system. 
 
 

A.  Voice Speaker 

B.  LED indicator 

C.   Siren 

D. 

Temperature Sensor 

E. 

Battery Mylar 

F. 

Screw Mount 

G. Backplate 

H. Opening 

slot 

I.  Battery 

J. 

Mini USB connector 

K. 

Link button 

L.      Tamper switch 

 

The voice siren supports Auto Inclusion feature where it will automatically enter Inclusion mode when first 
powered up after a factory reset. 
 
Note: Depending on country, the unit may be shipped with batteries already inserted. In this case, simply 
pull out the Battery Mylar, set the Z-wave controller into Inclusion mode and then proceed to step 4. 
 
1. 

Carefully remove its back cover by peeling from the opening slot at the bottom.   

2. 

Set the Z-wave controller into Inclusion mode. 

3. 

Insert the battery into the battery compartment. Note the correct polarity of battery as indicated. 

 

 

 

 

 

 

 

 

4. 

The unit’s LED will start to blink. The duration of Inclusion mode is 30 seconds. 

5. 

The Inclusion process should be completed when the LED stops blinking. 

 
Note: If you are connecting this unit to a Z-Wave Controller that utilizes the S2 security protocol, you may 
be asked by your controller to enter a 5-digit Device Specific Key (DSK) that is unique to each unit. This 
can be found in one of two places: 
- on the QR code label on the back of the unit 
- on the insert card inside the packaging. 
 
If Auto Inclusion fails, refer to the Troubleshooting section regarding Manual Inclusion. 
 

 

Before downloading audio files into the voice siren, the audio files need to conform to the format below. 

 
- Format : WAVE format (file extension ‘.wav’) 
- Sample rate : 8KHz~32KHz. 
- Mono only 
- Maximum length : 30 seconds for each file 
 
Note: MP3 file needs to be converted to .wav format. 
 

1. 

Use a sound editor software on a PC to modify the audio files to fulfill the format above. 

2. 

Save the files into a folder. Ensure the total size of all the files do not exceed 2MByte in size, which 
is roughly 85 seconds of playback. 
 

A PC running Microsoft Windows Operating System and a Mini USB cable is needed. Ensure also 
batteries are inserted into the voice siren, otherwise downloading will not work. 
 
1. 

Connect the voice siren to the USB port of the PC with the Mini USB cable.