Everspring Industry Co Ltd TR003-04 Benutzerhandbuch

1 

 

The AN145 Screw-in On/Off Module is a transceiver which is a Z-Wave

TM

 

enabled device and is fully compatible with any Z-Wave

TM

 enabled network. 

Z-Wave

TM

 enabled devices displaying the Z-Wave

TM

 logo can also be used with 

it regardless of the manufacturer, and ours can also be used in other 
manufacturer’s Z-Wave

TM

 enabled networks. Inclusion of this Module on other 

manufacturer’s Wireless Controller allows remote turn-on of On/Off status. Each 
Module is designed to act as a repeater.  Repeaters will re-transmit the RF 
signal to ensure that the signal is received by its intended destination by routing 
the signal around obstacles and radio dead spots. 
 
 

In the front casing, there is an On/Off knob coupled with LED indicator which is 
used to carry out inclusion, exclusion or association. Put a Z-Wave

TM

 Wireless 

Controller into inclusion/exclusion mode, press the knob on the Module to 
complete the inclusion/exclusion process.   

 

As soon as the light bulb is screwed into the lamp holder, the LED on the Module 
will be flashing slowly.    This implies that the Module is not included in Z-Wave 
system and cannot be controlled by the Wireless Controller. However, pressing 

the On/Off knob will control directly the On/Off status of the connected 
incandescent lamp without using the Wireless Controller. 
 
(1)    Turn off the wall switch on the wall or mains power supply. 
(2)    There are three types of lamp caps – B22, E26, E27.    Choose whichever 

suits you most. 

(3)  The Module is designed for ceiling mounting. Fit the Module into the 

existing lamp cap.   

(4)    Place the light bulb into the lamp holder. 
Note: The Module cannot be screwed in an air tight environment/ lamp stand. 
 
 
 
 
 
 
 
 
 
 
 
 

 
To turn on or off the incandescent lamp controlled by the Module:   
 
 Simply press and release the On/Off knob. The red indicator LED will turn 

On/Off and the incandescent lamp screwed into the Module will also turn 
On/Off. 

 With Z-Wave controller: simply press On or Off button on the controller. 
 With Z-Wave routing slave: To do association between routing slave and 

Module through Z-Wave controller, the routing slave can control the On/Off 
status of Module. 

 
 

 
As long as any Z-Wave

TM 

enabled device that can send below mentioned alarm 

command  
 
( ALARM_ REPORT, Alarm Type ==0x01,Alarm Level ==0x11) 

B22 lamp cap

E26/E27 lamp cap

LIGHT BULB

B22 lamp cap

E26/E27 lamp cap

ON/OFF KNOB
LED INDICATOR