Semnox Solutions Private Limited SPRW001 Benutzerhandbuch
PARAFAIT HARDWARE MANUAL
2011
S E M N O X S O L U T I O N S P V T L T D .
Page 11
J4 Connector: Connect the FRC Connector from Reader, which carries
the power supply & control signals.
Switch
SW1: Output Sensor pulse pull ups. This is used to generate the
sensor pulse in e-ticket mode.
SW2: Input Activation signal pull ups. This is used to reduce the noise
in the signal.
SW3: Output Activation signal pull ups. This is used for proper
termination to Ticket Dispenser in e-Ticket mode.
SW4: Input Sensor Pulse signal pull ups. This is used to reduce the
noise in the signal.
SW5: Output Coin pulse pull ups. This is used to generate the Coin
pulse to start the game.
Interfacing boards can be configured in 3 ways.
1. Non Redemption Machine: In this configuration Parafait Reader
the power supply & control signals.
Switch
SW1: Output Sensor pulse pull ups. This is used to generate the
sensor pulse in e-ticket mode.
SW2: Input Activation signal pull ups. This is used to reduce the noise
in the signal.
SW3: Output Activation signal pull ups. This is used for proper
termination to Ticket Dispenser in e-Ticket mode.
SW4: Input Sensor Pulse signal pull ups. This is used to reduce the
noise in the signal.
SW5: Output Coin pulse pull ups. This is used to generate the Coin
pulse to start the game.
Interfacing boards can be configured in 3 ways.
1. Non Redemption Machine: In this configuration Parafait Reader
control the Game play when a valid tap happens.
The only connection required (apart from the power and ground)
is the coin pulse. The coin pulse wire is tapped and connected to
the interface board using the connector J3. See below table to get
detailed pin description.
The only connection required (apart from the power and ground)
is the coin pulse. The coin pulse wire is tapped and connected to
the interface board using the connector J3. See below table to get
detailed pin description.
2. Redemption Machine: In this configuration Parafait Reader
Control the Game plays when valid tap happens & controls the
ticket out. Use connectors J1, J2, J3 to interface the machine with
interfacing board. See below table to get detailed pin
descriptions.
ticket out. Use connectors J1, J2, J3 to interface the machine with
interfacing board. See below table to get detailed pin
descriptions.
3. Ticket Eater: In this configuration Parafait Reader will function as
ticket eater and count the tickets and load to the respective card.
Use connectors J1 & J2 to interface the machine with Interfacing
Board. See below table to get detailed pin descriptions.
Use connectors J1 & J2 to interface the machine with Interfacing
Board. See below table to get detailed pin descriptions.