Honeywell International Inc. HD-128 Benutzerhandbuch

CONFIDENTIALITY STATEMENT

This document contains information that is private and Confidential, and is supplied on the express condition that it is not to be

used for any purpose other than the purpose for which it was issued, nor is it to be copied or communicated in whole or in part, to

any third party other than the recipient organization, without the prior written permission of EMS Technologies Canada, Ltd.

HSD Aeronautical Transceivers

Troubleshooting calls

The following section provides basic troubleshooting
information that includes symptoms and suggested solutions.

Troubleshooting voice calls

Symptom

Solution

The number you have dialed may be

incomplete or incorrect.
Check your number and try again. For the correct

number format, refer to the calling instructions

provided in this User’s Guide.

A toll-free number was dialed.
Most toll-free numbers do not work with the

aeronautical Satcom Network.

The pound key # was not pressed.
When placing a call from air-to-ground, the #

pound key must be pressed to initiate the calling

sequence.
Try your call again, making sure that you end your

dialing sequence by pressing #.

Call does not

ring through.
No tone is

audible even

after 30 to 60

seconds.

Physical connection to the HSD Transceiver or

attached user devices may be broken.
Check all wiring connections and try your call again.

System has not cleared previous calls.
Dial tone must be audible; dial tone indicates that

the system is ready. If dial tone is not audible, hang

up and wait 30 seconds for the system to clear, and
then try your call again.

Call does not

ring through.
Fast busy

signal is

audible in

handset.

The System is busy or is in a transient state.

(The system may be logging-on, changing

beams, or acquiring a satellite or LES.)
Listen for dial tone before placing your call.