Badger Meter Inc 4545 Benutzerhandbuch
Recommended Installation Procedure:
(for pit lid installation)
1.
Using the four machine screws and lock-nuts with the nylon inserts provided, attach
CellinK™ to CellinK side of Mounting Bracket. Ensure to mount CellinK as space
allows, either normal position or 90º offset.
CellinK™ to CellinK side of Mounting Bracket. Ensure to mount CellinK as space
allows, either normal position or 90º offset.
(See Fig 1 for normal mounting or Fig 2 for 90
°
offset mounting)
2.
Insert Antenna Coax Cable and Antenna Base through pre-drilled hole in Pit Lid.
(See Fig 3)
3.
Slide Spacer over Antenna Coax Cable and Antenna Base.
(See Fig 3)
4.
Feed Antenna Coax Cable through center hole on Antenna side of Mounting Bracket
and, using the two Antenna Mounting screws provided, attach Mounting Bracket to
Antenna Base. Ensure that Antenna Mounting Screws are fed into the CENTER
holes on Antenna Base. Also, ensure that Mounting Bracket is positioned as to allow
for proper clearance between the CellinK and the Pit wall, Meter/RTR, and other pit
contents.
and, using the two Antenna Mounting screws provided, attach Mounting Bracket to
Antenna Base. Ensure that Antenna Mounting Screws are fed into the CENTER
holes on Antenna Base. Also, ensure that Mounting Bracket is positioned as to allow
for proper clearance between the CellinK and the Pit wall, Meter/RTR, and other pit
contents.
(See Fig 3)
5.
Connect Antenna Coax Cable to CellinK Coax connector and wrap with Coax Cable
Sealing Tape. Ensure to cover all exposed metal of Coax connector and compress
tape tightly to provide proper water-proofing.
Sealing Tape. Ensure to cover all exposed metal of Coax connector and compress
tape tightly to provide proper water-proofing.
(See Fig 3)
6.
Connect RTR cable to CellinK RTR Cable (Black Connector).
(See Cable Connecting Procedure)
7.
Connect Battery cable to CellinK Battery Cable (White Connector).
(See Cable Connecting Procedure)
8.
Mount RTR to Meter Body and secure in place with seal screw.
9.
Return pit lid to pit. Ensure all pit contents have proper clearance - no equipment
should be “forced” into position. Also, ensure no cables are pinched between lid and
pit.
should be “forced” into position. Also, ensure no cables are pinched between lid and
pit.
FCC ID: GIF4545
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation
!WARNING!
Any modifications to the unit, unless expressly approved by the party responsible
for compliance, could void the user’s authority to operate the equipment.
This product is intended to be installed, operated, and used only by properly trained
professionals, in accordance with FCC rules and regulations.