Badger Meter Inc HREBT Benutzerhandbuch

Applications: The BadgerTouch® Single Remote Module coupled 

with the High Resolution Encoder (HRE) or Absolute Digital Encoder 

(ADE®) is a complete electronically encoded close-proximity 

automated meter reading system, specifically designed for single 

point remote meter installations. This system can be used with all 

currently available Badger Meter Recordall® Disc, Turbo, Compound, 

Combo, Fire Series meters and assemblies.

Communication: Communication is accomplished by using 

compatible reading devices programmed to read BadgerTouch 

or Sensus protocols, such as the VersaProbe reading wands, to 

interrogate the BadgerTouch remote module. The remote module 

responds with its serial number, water meter reading, and transmits 

data in approximately 2.5 seconds. In the event a tamper condition 

exists, the data collector will not receive a reading.

Performance: The Badger Meter BadgerTouch meter reading 

system offers operating performance in a variety of applications 

under most climatic conditions. For consistent results, interrogation 

equipment should be placed in direct contact with the remote  

read pad.

Meter Reading Validation: Further validation of the meter 

reading can be made automatically by the data collector based 

on comparison of high-low audit fields in the record. If the meter 

reading is not between these predetermined limits, an error 

message is displayed on the data collector display.

Wire Connections: The BadgerTouch Remote Module can be 

installed in new or existing installations where remote meter 

reading is required. The remote module is connected to the 

recommended wire that runs between the module and the HRE 

or ADE. A set of terminal screws on the remote module makes 

this connection. The HRE or ADE is provided prewired with a 

3', 6', 10' 15' or 25' length of wire that is ready for connection in 

existing installations. Please see Figure 1 for more information 

on connections. To provide best results, a maximum of 75 feet of 

wire (Belden #9770) between the remote module and the encoder 

is allowed. Other wire types may also affect performance. If an 

additional length of wire is used in addition to that provided with 

the encoder, a set of gel splices must be made.

Construction: The Badger Meter BadgerTouch remote module 

enclosure is constructed of a high impact plastic enclosure designed 

for most remote locations. All internal electronic components are 

encapsulated to provide environmental protection. The HRE and 

ADE provide permanent glass/metal packaging in a plastic shroud 

and lid for long lasting, highly reliable encoded meter reading 

information collection.

License Requirements: This device complies with Part 15 of the 

FCC Rules. Operation of this device is subject to the following two 

conditions: (1) This device may not cause harmful interference, and 

(2) this device must accept any interference received, including 

interference that may cause undesired operation. Any changes 

made by the user not approved by Badger Meter can void the user’s 

authority to operate the equipment. No license is required by the 

utility to operate a BadgerTouch meter reading system.

–5…120° F (–20…49° C)

–5…120° F (–20…49° C)

0% to 100% Condensing

Remote enclosure is UV protected for 

outdoor installation.

The remote module has a high impact 

weather proof plastic enclosure 

containing encapsulated electronics 

and reading coil. The HRE and ADE is 

constructed of a permanently sealed 

glass and copper corrosion-resistant 

metal can design.

Two terminal screws for connecting 

the HRE or ADE lead wire to the 

remote module.

Noncorrosive tamper resistant TORX® 

seal screw mounted on the HRE or 

ADE shroud and remote housing 

(optional proprietary keyed seal screw 

available).

6 ounces (not including the encoder)