Compal Electronics Inc PICONODE Benutzerhandbuch
PicoNode Integration Specification
36
9.3 Block Diagram
Some regulatory domains require a block diagram of the module for their documentation
similar to that shown in the following figure.
similar to that shown in the following figure.
Figure 14 picoNode Block Diagram
9.4 Antennas
9.4.1 Host Antenna Trace Design
To connect RF signal from the module’s RF pins to the antenna, RF connector, or matching
network, 50 ohm-controlled impedance traces should be used. Vias may be used to transition
the RF from one signal layer to another signal layer.
network, 50 ohm-controlled impedance traces should be used. Vias may be used to transition
the RF from one signal layer to another signal layer.
The following controlled impedance RF traces are allowed:
Surface microstrip
Surface coplanar waveguide (CPWG)
Surface ground-backed CPWG
Embedded microstrip
Embedded CPWG