Psion Inc UHFCA2A5 Benutzerhandbuch
August 29, 2007
DPD A00299 A20 Sheet 1 of 3
W
ORKABOUT
P
RO
G
2
RFID MODULE UHF-CA2-A5
E
XPANSION
M
ODULE
I
NSTRUCTIONS
Important: All Approval and safety information is outlined in the ‘Workabout pro G2 Handheld-computer
User Manual’ – part number 8100140A. This manual is available on our website
www.psionteklogix.com
through the Teknet extranet.
Important: The WORKABOUT PRO G2 with the RFID option must not be held closer than 20 cm
from the rest of the body.
Important: The WORKABOUT PRO G2 with the RFID option must not be held closer than 20 cm
from the rest of the body.
This product must not be used in a holster or on a belt-clip.
Easily installable expansion modules for the WORKABOUT PRO allow you to customise this hand-held to
meet your specific mobile computing requirements. This chapter outlines how to install the RFID Module
UHF-CA2-A5 (this module is composed of one RFID Coupler UHF-CA2 and RFID Antenna UHF-A5).
Before installing a module in the WORKABOUT PRO G2, all power sources must be turned off.
• Remove the batteries. If your unit is using AC power, disconnect it.
• Stick the FCC / IC Label
(FCC ID: GM3UHFCA2A5, IC ID: 2739D-UHFCA2A5)
underneath the battery.
WAP C G2 WAP S G2
• Slide the switch to position OFF to shut off internal battery power.
With the power shut down, you can install the RFID Module UHF-CA2-A5-G2.
• Remove and discard the two screws on the bottom of the metal frame.
• Put the RFID Coupler UHF-CA2 in the same alignment of the expansion connector on the
WORKABOUT PRO G2. Apply slight pressure to snap the module into place on the hand-held.
• Use four new screws (M2 x 6 mm) provided to secure the module in place.
Label area
Label area