Psion Inc UHFCA3A5 Benutzerhandbuch
July 08, 2010
DPD A00531 A00 Sheet 1 of 7
W
ORKABOUT
P
RO
RFID MODULE UHF-CA3-AC5-XMOD
E
XPANSION
M
ODULE
I
NSTRUCTIONS
Important: All Approval and safety information is outlined in the ‘Workabout pro Handheld-computer User
Manual’ – part number 8100140A. This manual is available on our website
www.psionteklogix.com
through the community website
http://community.psionteklogix.com/home/default.aspx
.
Important: The WORKABOUT PRO with the RFID option must not be held closer than 20 cm from
the rest of the body.
This product must not be used in a holster or on a belt-clip.
Easily installable expansion modules for the WORKABOUT PRO allow you to customise this hand-held to
meet your specific mobile computing requirements. This chapter outlines how to install the RFID Module
UHF-CA3-AC5-XMOD (this module is composed of one RFID Coupler UHF-CA3-XMOD and RFID
Circular Antenna 915 MHz).
Before installing a module in the WORKABOUT PRO, all power sources must be turned off.
• Remove the batteries. If your unit is using AC power, disconnect it.
• Stick the FCC / IC Label
(FCC ID: GM3UHFCA3A5, IC ID: 2739D-UHFCA3A5)
underneath the battery.
WAP C G2 WAP S G2
• Slide the switch to position OFF to shut off internal battery power.
With the power shut down, you can install the RFID Module UHF-CA3-AC5-XMOD.
• Remove and discard the two screws on the bottom of the metal frame.
Label area
Label area