GEMMY INDUSTRIES LIMITED BVI 3002018 Benutzerhandbuch

E-4

batteries of a set at the same time. 6. Use only batteries of the same or equivalent type as recommended by the manufacturer. 

7. Be sure to insert batteries with correct polarities and always follow manufacturers’ instructions. 8. Remove exhausted 

batteries from product promptly. 9. Do not short-circuit supply terminals. 10. Remove batteries before storage or extended 

periods of non-usage. 11. Clean the contacts on the batteries and the device prior to battery installation. Non-rechargeable 

batteries are not to be recharged. Rechargeable batteries are not recommended for use in this product. If rechargeable 

batteries are being used, however, please follow these guidelines. (1).Rechargeable batteries should be removed from the 

product before being charged. (2). Rechargeable batteries should only be charged under adult supervision.

When using electrical products, basic precautions should always be practiced including the following:

  1.

  

2.  Read and follow all instructions that are on the product or provided with the product.

  3. Do not use an extension cord.

  4.  Reference the National Electrical Code, ANSI NFPA 70, specifically for the installation of wiring and clearances from 

power and lighting conductors.

  5.  Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and 

standards, including fire-rated construction.

  6. Do not install or use within 10 feet of a pool.
  7. Do not use in a bathroom.

  8.  

 Risk of Electric Shock. 

When used outdoors, install only to a covered Class A GFCI protected 

receptacle that is weatherproof with the power unit connected to the receptacle. If one is not provided, contact a 

qualified electrician for proper installation. Ensure that the power unit and cord do not interfere with completely closing 

the receptacle cover.

9. 

Installation involves special wiring methods to run wiring through a building 

structure. Consult a qualified electrician.

 10.  If the connector of this driver does not properly fit into the connector of the lighting string, do not modify the product 

and discard product if the connector is damaged.

 11.

Not for use with receptacles that are weatherproof only when the receptacle is covered 

(attachment plug cap not inserted and receptacle cover closed).

This manual contains important safety and operating 

instructions for power units.

Changes or modifications to this unit not expressly approved by the party responsible for 

compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a 

residential installation.  This equipment generates, uses and can radiate radio frequency energy and, if not installed and used 

in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause 

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for hel

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may 

not cause harmful interference, and (2) this device must accept any interference   received,   including   interference   that   

may   cause undesired operation.