INNCOM International Inc. 202124TXR Benutzerhandbuch
INNCOM PC-502 Datasheet
P a g e
| 3
S5bus
GS-528H
E528.3G
PC-502.2
S55x Lamp
Controller
L208 Lamp
Controller
X07 HVAC
Controller
Layer-1 RF Network
Layer-2 RF Network
TCT.RF
Ethernet
B573-MBX
Figure 4 PC-502 Layer-2 Topology
In this application, the PC-502 in participation with the e528.3G provides the Layer-1 to Layer-2 RF Bridge where
both wireless in-room and wireless back-end networking are required. The PC-502 can also patch areas within the
Layer-2 network where signal strength is lost due to distance limitations or interference.
both wireless in-room and wireless back-end networking are required. The PC-502 can also patch areas within the
Layer-2 network where signal strength is lost due to distance limitations or interference.
Safety/Regulatory
Parameter
Condition
Status
FCC
Part 15b
FCC ID: GTC202124TXR
Warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC & ICC Compliance Statements
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
IC:1609A-202124TXR
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
IC:1609A-202124TXR