Climax Technology Co Ltd PB Benutzerhandbuch

                                                                       

The Panic Button is used to activate (or deactivate) a panic alarm. 

 

Button usage: 
1. Press to send a learn code or activate a 

panic alarm. 

2. Press and hold the button for 8 seconds to 

send a Cancel Code to the Control Panel. 
(This function is not compatiable with 
every control panel) 

LED Indicator: 

The LED indicator will light up briefly 
when the device is transmitting a signal. 

 

 

 

The Panic Button is powered by one CR2 3V Lithium battery. 

 

The Panic Button will transmit any detected low battery status along with any regular status 
signal transmission to the Control Panel for display accordingly.   

 

When changing battery, after removing the old battery, press the button twice to fully discharge 
before inserting new battery. 

 

 

 

The Panic Button will automatically transmit Supervisory Signals every 30 to 50 minutes. 

 

If the Control Panel has not received the signal from the Panic Button for a preset period of time, 
the Control Panel will indicate that the Panic Button is out-of-signal range or is out of order. 

 

 

 

Remove the cover-fixing screw using a Philips screwdriver and separate the cover from the 
base. 

 

Insert the battery according to the marked polarities. 

 

Replace the top over the base by hooking the base onto the fixing hook and pushing the cover 
towards the base. 

 

Lightly tighten the screw. 

 

Put Control Panel into learn mode 

 

Press the button on the Panic Button to transmit a learn code. 

 

Refer to your Control Panel’s operation manual to complete the learn-in process. 

 

 

 

Place the Control Panel in the walk test mode. 

 

Press the Button once. 

 

The Panel will display the RSSi (Radio Strength Signal) strength and sound a 2-tone beep.