Advance Security Inc T61 Benutzerhandbuch

Seite von 3
CHANGING THE BATTERY IN YOUR TRANSMITTERS
XT-53:
The XT-53 transmitter uses a 3-volt lithium ion batteries (#CR2032) To replace the battery,
you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the
transmitter case next to the key ring. Using the flat blade screwdriver, carefully pry the top case from the
bottom case. It should snap apart after breaking the seal. Before removing the batteries note the
direction of the positive (+) terminal. Place the new batteries in exactly the same manner, being careful
not to bend or damage the contact terminal. Snap the cases back together and then test the transmitter
to insure it arms and disarms the alarm.
TRANSMITTER OPERATION
Transmitter
Button
System Function
Remark
Lock Doors & Arm System
Panic function
Press and Hold for 3 seconds
Car Locator
Under armed mode
-
Arm and Delete The 2 Stage Shock
Sensor
Press twice within 3 seconds
+
Silent Arming / Disarming
Ignition in "off" position.
Unlock Doors & Disarm System
-
Two Steps Door Unlock & Disarm
System
Press twice within 3 seconds.
Trunk Release (Channel 3)
Press and Hold for 2 seconds
-
Passive Arming By-pass
While the system Disarmed.
Silent Arming / Disarming or 4
th
ch
+
Switching code For 2nd Car Operation.
SILENT LOCKING AND UNLOCKING: ARMING / DISARMING: Press the
button on the
transmitter to LOCK or UNLOCK your security system, No chirp sound will be heard; arm / disarm
confirmation will be through the vehicles parking lights only.
SHOCK SENSOR / OPTIONAL SENSOR BY-PASS: Pressing the
 
button on the transmitter twice
within 3 seconds will arm the security system and by-pass the shock sensor. The system will chirp
one additional time to confirm the sensor bypass mode was activated. The sensor bypass feature is
programmed to activate for one arming cycle only. The security system will return to normal operation
during the next arming cycle
PASSIVE LOCKING OR ARMING : Programmable
Active arming / disarming is controlling your security system via the remote transmitter. This
security system is equipped with an optional Passive Arming feature, which allows the security
system to arm 30 seconds after the last door is closed. Operation is as follows.
1.
Turn the ignition to the “OFF” position and exit the vehicle.
2.
After all entrances are closed, the security system LED will flash fast for 30 seconds. If you
reopen any door / hood / trunk, the security system LED will stop flashing. It will begin flashing
again once all vehicle entrances are closed.
3.
After 30-second timer has elapsed, the security system will automatically “ARM”. The siren or
horn will chirp [1] time and the parking lights will flash [1] time.
PASSIVE DOOR LOCKING: Programmable
The vehicle doors will automatically lock after passive arming cycle has been completed.
ACTIVE UN-LOCKING – UNLOCK & DISARM:
1. Press the
 
button on the transmitter.
2. The siren or horn will chirp twice and parking lights will flash twice to indicate that the security
system is now disarmed. The vehicle doors will unlock when interfaced with the security system.
TAMPER DISARMING: (OPTIONAL). If the alarm is triggered; Upon disarming the system the
siren or horn will chirp 4 times and parking lights will flash 3 times. This will indicate that the alarm
has been triggered while armed.
TWO STEP DOOR UNLOCK: (OPTIONAL) This feature will independently unlock the driver’s
door only when disarming the security system. Pushing the
 
button on the transmitter a second
time within 3 seconds will unlock the entire vehicle. (Optional, Additional installation required).
AUTOMATIC RE-LOCKING or RE-ARM: If this feature is selected, the security system will
automatically re-arm itself 60 seconds after disarming with remote transmitter. Automatic rearm will
cancel if any door is opened before the 60 seconds timer has elapsed.
DISARMING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will sound.)
2. Within 10 seconds push and release the valet switch
The alarm will stop sounding and enter the disarm mode. You can now start and operate the
vehicle normally.
VALET MODE:
The valet switch allows you to temporarily bypass all alarm functions eliminating the need to hand
your transmitter to parking attendants or garage mechanics. When the system is in valet mode,
all alarm functions are bypassed, however, the remote panic feature and remote door locks will
remain operational.
Enter Valet Mode:
1. Turn the ignition to “ON” position.
2.
Push and hold valet switch for 2 seconds or until the LED turns on. The LED will remain on as
long as the system is in 'valet mode'.
Exit Valet Mode:
1.
Return to normal operation, turn ignition 'ON'.
2.
Push and hold valet switch for 2 seconds; the LED will turn off indicating the system is exiting
the valet mode.
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of
emergency.
1.
Press and hold the
 
button on the transmitter for 3 seconds. The alarm will immediately
sound.
2.
To stop the alarm, press and hold the
 
button for 3 seconds on the transmitter, the panic
mode will be turned off immediately.
3.
If the button is not pressed, the alarm will automatically stop after 30 seconds.
TRIGGER THE SYSTEM: (OPTIONAL) If alarm option is installed.
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away signal. A long chirp from siren /horn.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the ignition switch- All will trigger the
programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren or horn and parking
lights will turn on to alert of an intrusion for 30 seconds. Then the siren or horn will stop and automatically reset
and re-arm. If any the sensors or detectors are still active, the alarm system will sound a maximum of three-30
second cycles.
ANTI CAR-JACKING: (OPTIONAL) If alarm option is installed.
Warning: If you don't need the carjacking function in this alarm system, be sure to set carjacking feature “OFF”.
This system is default setting Car-jacking “OFF”.
1. TRANSMITTER ACTIVATES THE CAR JACKING:
Press and hold
 
+
button on the transmitter for 1 second while the vehicle’s ignition is ON. The parking
light will turns on for 1.5” seconds to indicate car jacking activated.
2. DOOR SWITCH ACTIVATE CAR JACKING:
1. Turn the ignition switch to “ON” position, the system is armed.
2. Once the system is armed, if you are forced from the vehicle, the system will active the carjacking trigger
when the door is opened and closed while the ignition is “ON”.
TRIGGER THE CAR JACK MODE:
3-timer circuits will function as follows:
First timer:
a.
50 seconds after the system has been triggered. The siren or horn will start chirping for 15 seconds.
b.
During this 15 seconds period of chirping, you will be alerting to push the valet switch once to turn off the
car-jacking feature.
c.
If not, it will enter second timer car jacking.
Second timer:
65 seconds after the system has beer triggered. The siren or horn starts alarming and the parking light starts
flashing.
Third timer:
90 seconds after the system has been triggered
a.
The siren or horn will still be alarming and the parking light flashing.
b.
The starter disable will activate to prevent the vehicle from starting.
c.
It will remain active until the vehicle's battery power exhausted.
OVERRIDE THE SYSTEM TO TURN OFF CAR JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch. The siren or horn will
stop and the system will be disarmed
IGNITION CONTROL DOOR LOCKS.
If the vehicle’s door locks have been interfaced to the security system, the system will automatically lock the
vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is turned
“OFF”.
TRUNK RELEASE: Press and hold
button on transmitter for three seconds to remote control the trunk
release or other electric devices.
CAR LOCATOR : Press the
 
button on the transmitter when the vehicle is in the armed / locked mode to active
car locator function. The siren or horn will chirp 6 times. The parking light will flash 12 times, allowing you to easily
locate your car.
ALARM OPERATING CONDITION: (OPTIONAL)
Function
Siren or horn
Parking Lights
LED
Doors
Starter
Disable
1. Arm
1 Chirp
1 Flash
Slow flash
Locking
On
2. Disarm
2or4 Chirps
2 or 3 Flashes
Off or Fast flash Unlocking
Off
3. Trigger
Alarming
Flashing
Slow flash
On
4. Panic
Alarming
Flashing
Slow flash
Locking
On
ACTIVE LOCKING – LOCK & ARMING:
1. Press
 
button on transmitter.
2. The siren or horn will chirp once and the parking lights will flash once indicating that the system is
now armed. The vehicle doors will lock upon arming when interfaced with the security system.
Note: Defective sensor reminder: If the siren or horn sounds 3 chirps, then you have left a door, trunk,
or hood lid ajar. (OPTIONAL)
LIMITED LIFETIME WARRANTY PROVISIONS
( U.S. ,Continental U.S. and Canada Only)
VARAD International offers an industry-leading lifetime system warranty on the Autopage brand of remote start and security
products which protects users of its products from defects in material and workmanship under normal use and circumstances. This
warranty only covers materials both sold and installed by an "Authorized Dealer" of Autopage product
"Authorized Dealer" is defined by VARAD International as a company who qualifies to purchase Autopage products directly from
VARAD International, or one of its approved distributors. Thus, products not sold nor installed by an "Authorized Dealer" are not
covered by this warranty. This includes, but is not limited to, Autopage products sold on Amazon.com that are not supplied directly
by Amazon or eBay.com. If you would like more information on "Authorized Dealer" locations, please e-mail
Customerservice@Varad.com or visit www.Autopageusa.com.
Autopage Lifetime System Warranty does NOT cover remote transmitters, or RF kits, as these materials are covered by a separate
warranty. Autopage remote transmitters are covered by a 1-year warranty, which protects users from defects in material and
workmanship.
VARAD International warrants to the original purchaser that this product shall be free of defects in material and workmanship under
normal circumstances for the period of time that the original owner of this product owns the vehicle in which it is first installed;
except that the remote controller unit, or "brain", for the period of five years from the date of installation to the original owner of this
product. When purchased or prepaid postal to VARAD International, 5349 Zambrano Street, Commerce,CA, USA within the
warranty period, and if the product is defective, VARAD International i.e. Autopage will at its own option, repair or replace as such.
To the maximum extent allowed by law, any and all warranties are excluded by the manufacturer and each entity participating in the
stream of commerce there with. This exclusion includes but is not limited to, the exclusion of any and all warranty of merchantability
and/or any and all warranty of fitness for a particular purpose and/or any and all warranty of non-infringement or patents, in the
United States of America and/or abroad. Neither the manufacturer of any entities connected therewith shall be responsible or liability
for any damages whatsoever, including but not limited to, any consequential damages, incidental damages, damages for loss of time,
loss of earnings, commercial loss, loss of economic opportunity and the like, notwithstanding the above, manufacturer does offer a
limited warranty to replace or repair the control module, or "brain", as described above.
Some states do not allow limitations on how long an implied warranty will last or the exclusion or limitation on how long an implied
warranty will last or the exclusion or limitation of incidental or consequential damages. This warranty gives you the specific legal
rights, and you may also have other rights, which vary state to state.
VARAD International i.e. Autopage, is not responsible or liable for any damages whatsoever, including but not limited to, any
consequential damages, incidental damages, damages for loss of time, loss of earnings, commercial loss, loss of economic
opportunity, and the like that may or may not result from the operation of Autopage products. Not with standing the above, VARAD
International i.e. Autopage does offer a limited warranty to replace or repair the control module, or "brain", as described above.