HeathCo LLC 5985BLE Benutzerhandbuch

5 HOMEDEPOT.COM

Please contact 1-866-308-3976 for further assistance.

NOTE: The light fixture should be mounted approximately 
8 ft. (2.4 m) above the ground. If the light fixture is 
mounted higher than recommended, aiming the sensor 
down will reduce the coverage area.

 

Ƒ Determine the mounting location – wall or eave 

mount.

 

Ƒ Position the lamp heads (A) in the general 

direction of the desired light coverage.

 

Ƒ If needed, rotate the motion sensor (C) so the 

text faces upward.

Wall Mount

Eave Mount

NOTE: This fixture comes with a 1-2- asy Connect™ (D). 
It is pre-assembled on the light fixture (B) for shipping.

NOTE: The large mounting bolt (EE) is pre-installed in 
the light fixture (B). Do not attempt to remove the large 
mounting bolt (EE).

 

Ƒ Unscrew the large mounting bolt (EE) connecting 

the light fixture (B) to the 1-2- asy Connect™ (D) 
and remove the 1-2- asy Connect™ (D).

WARNING: Turn the power off at the circuit breaker or 
fuse. Place tape over the circuit breaker switch and verify 
power is off at the light fixture.

NOTE: Six mounting bracket screws of various sizes are 
included. The installation will only require two. Discard the 
unused mounting bracket screws after installation.

 

Ƒ Remove the existing light fixture.

 

Ƒ Install the mounting bracket (GG) with the 

stamped word “FRONT” facing away from the 
junction box. Use the mounting bracket screws 
(BB, CC, or DD) that best fit the junction box.

 

Ƒ Firmly pull on the mounting bracket to verify 

it is securely mounted to the junction box. If 
necessary, use the screws that were removed 
from the existing light fixture.

A

C

EE

D

B

BB, CC, or DD

GG