TOMY International Inc. 52614TX27 Benutzerhandbuch

1. Remove battery cover as shown and install  

(2) AAA / LR03 1.5 Volt batteries. Replace 
cover. Move power button 

“ON” and the red 

LED light will come on. This will show you 
that the battery is good and the transmitter 
is ready for operation. PLEASE 

NOTE: Vehicle 

power switch must be in the 

“ON” position 

to receive commands from the transmitter.

2. Change batteries when LED is dim or not on.

SAFETY PRECAUTIONS (Keep manual for future reference)
This vehicle is not recommended for children under the age of 6 years. Please read all of the instructions before operating this 
vehicle. Always follow general safety rules while operating vehicle: avoid hitting pets, furniture or people. Do not pick up vehicle 
while it is in motion, keep hands, hair and clothing away from this vehicle when the power switch is turned to the “ON” position. 
Remove batteries when vehicle is stored. Avoid tire contact on painted or varnished surfaces.
The JLX MICRODRIVE™ is built with an automatic shut-off function if the vehicle reaches excessive temperature during 
operation. If the vehicle stops after prolonged period of operation, turn off vehicle and controller, remove batteries from vehicle 
and cease operation for ten (10) minutes. Reinsert batteries and resume play.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this unit not expressly approved by the party respon-sible for compliance could void 
the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation.

“Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this 
device must accept any interference, including interference that may cause undesired operation of the device.”
Carrier frequency and field strength
Frequency Channel: 27.145 MHz
27.145 MHz Field Strength: 68.7 dBµv/m @ 3m.

• Non-rechargeable batteries are not to be recharged;
• Rechargeable batteries are only to be charged under adult supervision;
• Rechargeable batteries are to be removed from the toy before being charged;
• Different types of batteries or new and used batteries are not to be mixed;
• Batteries are to be inserted with the correct polarity(+ and -);
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) 

batteries; 

• Exhausted batteries are to be removed from the toy;
• The supply terminals are not to be short-circuited;
• Only use the batteries recommended by the manufacturer or batteries of an 

equivalent type;

• Please remove from the toy if it is not to be used over a longer period;
• Protect the environment: Bring used batteries to a special collecting point! 

Thank you!

Cut line

Folder line