Philips Consumer Lifestyle AD905W Benutzerhandbuch
IFU AD905W
Author: JDR/EDN
Date: 30/11/2002
Instruction For Use (IFU) for Wireless Audio set AD905W
a) Unpack all parts: transmitter, receiver/amplifier, 14V adapter, table stand
b) Connect the rear speakers terminals to the appropriate connector sockets of the
b) Connect the rear speakers terminals to the appropriate connector sockets of the
receiver/amplifier.
c) Place the receiver/amplifier unit at a minimum of 30cm above ground to avoid bad
wave propagation; use the table stand as shown in the picture
d) Connect receiver/amplifier to mains by use of power cord.
e) Green led receiver/amplifier should light
f) If led is not lighting, shift small power switch next to the connectors to the ON
e) Green led receiver/amplifier should light
f) If led is not lighting, shift small power switch next to the connectors to the ON
position. Green led should light now.
g) Place the transmitter unit at a minimum of 30cm above ground to avoid bad wave
propagation. Make sure transmitter and receiver are not closer than 2m from each
other.
other.
h) Connect the 14V power adapter to the transmitter
i) Connect transmitter-inputs to DVD surround – output. Be sure to connect right input
i) Connect transmitter-inputs to DVD surround – output. Be sure to connect right input
to right output connector of DVD, idem for left channel? Mach the Blue and Grey
colour.
colour.
j) Power up the transmitter. Red led of transmitter unit should light now.
k) Make sure that transmitter and Receiver/amplifier are using same audio
k) Make sure that transmitter and Receiver/amplifier are using same audio
transmitting/receiving channel. Please select same channel by use of the 4-position
switch on both units.
switch on both units.
l) Start the audio source, be sure that surround - mode is enabled. Set volume to position
5; surround sound should be audible in the rear speakers.
m) Rotate antenna of both receiver/amplifier and transmitter into vertical position for
good reception
n) Red led on transmitter is on for at least 4 minutes. After switching off the DVD player,
the transmitter goes automatically to standby mode after 4 minutes= red led off; when
there is an incoming audio-signal from the DVD, the transmitter starts automatically.
The transmitter is also enabled at power – up for at least 4 minutes.
there is an incoming audio-signal from the DVD, the transmitter starts automatically.
The transmitter is also enabled at power – up for at least 4 minutes.
o) Receiver-amplifier combination is always on for at least 10 minutes = green led on.
When the transmitter stops (red led off), the receiver-amplifier will mute, green led
stays on, and after ten minutes the amplifier-receiver goes into s leep-mode = red led
on
stays on, and after ten minutes the amplifier-receiver goes into s leep-mode = red led
on
p) When distorted audio is noticed, please select different channel as the interference
could be caused by other equipment in your house using same freq. channel or even by
one of your neighbours.
one of your neighbours.
q) The metal table stand can be used for slightly upright position of the receiver/amplifier
unit. If used, make sure you rotate the antenna towards vertical position.