Horizon Hobby LLC HBZG2 Benutzerhandbuch

11

CAUTION: DO NOT handle propeller parts 

while the fl ight battery is connected. Personal 
injury could result

1.  Remove the spinner (A) by carefully pulling it 

away from the propeller (B). Remove residue 
from the spinner and propeller if applicable.

2.  Remove the propeller from the motor shaft, 

noting the “L” or “R” indicator. Use a pair of 
needle nose pliers or hemostats to hold the 
motor shaft (C) in place, then carefully pull 
the propeller from the motor shaft.

3.  Install a new propeller with the size numbers 

facing out from the motor. 

 • 

4.75 x 2.5 R (Right)

 • 

 

4.75 x 2.5 L (Left)

4.  Reinstall the spinner using foam 

safe CA (Cyanoacrylate adhesive).

A list of available replacement parts is in 
the back of the manual. Visit the web site 

www.????????????.com

 for more information 

about maintaining your aircraft.

If your aircraft does not respond to the 
transmitter when the batteries in the aircraft and 
transmitter are fully charged, bind your aircraft 
and transmitter by using the instructions below.

1.  Disconnect the fl ight battery from the aircraft.

2.  Power off the transmitter.

3.  Connect the fl ight battery to the aircraft. The 

receiver LED will begin to fl ash (typically after 
5 seconds)

4.  Hold the transmitter more than 24 inches 

(60 cm) away from the aircraft. Keep away 
from large metal objects, wireless sources 
and other transmitters. Make sure your 
transmitter’s controls are neutral, the throttle 
is in the low position, and the aircraft is 
immobile.

5.  Push the right control stick into the case until 

it clicks, as you power on the transmitter.

6.  The transmitter will beep twice and the LED 

will fl ash. Release the stick after 2 seconds.

7.  After 5 to 10 seconds, the receiver status LED 

will begin fl ashing slowly and the transmitter 
will stop beeping, indicating the receiver is 
bound to the transmitter.

(60 cm)