DoubleSight DS-EXT3 Merkblatt
HEIGHT EXT (1EA)
M6-80 BOLT (2EA)
5mm WRENCH (1EA)
(ALL MODELS)
POLE ADAPTER (1EA)
3/4” SCREWS (2EA)
Compatible with Flex Stand Models:
DS-130STB, DS-219STA, DS-219STB, DS-224STA, DS-319STA, DS-424STA
DS-130STB, DS-219STA, DS-219STB, DS-224STA, DS-319STA, DS-424STA
Package Contents :
Installation for Flex Stands :
1 - Remove existing base from Flex Stand.
Remove Monitors from your stand and lay stand on flat surface to reveal the underside of the stand base.
Use the 4mm which was included with the Flex Stand to remove the (2) screws in the bottom of the base.
Set screws aside for step 4 - final installation.
Remove Monitors from your stand and lay stand on flat surface to reveal the underside of the stand base.
Use the 4mm which was included with the Flex Stand to remove the (2) screws in the bottom of the base.
Set screws aside for step 4 - final installation.
3 - Install Height Extension Module.
Using the enclosed 5mm wrench, attached the Height Extension to the bottom of the Stand Pole with the
(2) enclosed bolts (M6-80).
Using the enclosed 5mm wrench, attached the Height Extension to the bottom of the Stand Pole with the
(2) enclosed bolts (M6-80).
4 - Reinstall Flex Stand Base
Reattach the original stand base to the bottom of the Stand Pole which now has the Height Extension
installed.
Reattach the original stand base to the bottom of the Stand Pole which now has the Height Extension
installed.
Zo
om
2 - Install Pole Adapter
Using the (2) 3/4” screws, attach the Pole Adapter to the bottom end of the stand pole. Use the 4mm
wrench to tighten the screws.
Using the (2) 3/4” screws, attach the Pole Adapter to the bottom end of the stand pole. Use the 4mm
wrench to tighten the screws.
Model: DS-EXT3
3” Height Extension for DoubleSight Multi Monitor Flex Stands
Compatible with Tier Extension Models:
DS-21T, DS-22T, DS-23T
DS-21T, DS-22T, DS-23T