HM Electronics Inc COM6000BP Benutzerhandbuch
7
6. Battery Removal and Replacement
TO CHANGE BATTERIES: When a battery becomes weak, a voice in the earpiece will say
“Change battery.” When this happens, take the Communicator out of its pouch and remove its
battery. Slide the battery-release latch in the direction of the arrow shown in Figure 6. Pull up
on the end of the battery near the battery-release latch and lift the battery out of the
Communicator, or turn the Communicator over and catch the battery in your hand.
“Change battery.” When this happens, take the Communicator out of its pouch and remove its
battery. Slide the battery-release latch in the direction of the arrow shown in Figure 6. Pull up
on the end of the battery near the battery-release latch and lift the battery out of the
Communicator, or turn the Communicator over and catch the battery in your hand.
TO REPLACE BATTERIES: When replacing a battery in the Communicator, place the end of
the battery with the metal contacts into the battery holder on the Communicator, in the same
position as the battery you removed. Press the top of the battery carefully into the battery
holder until it snaps in place under the battery-release latch.
the battery with the metal contacts into the battery holder on the Communicator, in the same
position as the battery you removed. Press the top of the battery carefully into the battery
holder until it snaps in place under the battery-release latch.
C. Battery Charger
• Insert battery in one of four charging ports until it clicks in place.
• Yellow light next to each battery port stays on while port is empty. When battery is in port, yellow
• Yellow light next to each battery port stays on while port is empty. When battery is in port, yellow
light flashing next to battery port indicates CHARGE PENDING, which means the temperature
where the charger is located is out of the battery’s operating range (32
where the charger is located is out of the battery’s operating range (32
o
-104
o
F, 0
o
-40
o
C). Adjust
the room temperature or move the charger to a cooler area. When battery is in port, yellow light on
steady next to battery port means CHARGE FAILED. Follow diagnostic instructions on side of
battery charger.
steady next to battery port means CHARGE FAILED. Follow diagnostic instructions on side of
battery charger.
• Red CHARGING light next to battery port stays on while battery is charging.
• Green READY light next to battery port goes on when battery is fully charged.
• Store fully charged batteries in storage ports.
• Green READY light next to battery port goes on when battery is fully charged.
• Store fully charged batteries in storage ports.
CAUTION: Do not remove batteries from the charger until the green READY
light is lit, or the charger will reset and the charge cycle will begin again.
light is lit, or the charger will reset and the charge cycle will begin again.
Battery-release
latch
Figure 6. Communicator battery-release latch
Figure 7.
Batteries in charger
Batteries in charger
Battery in
charging port
Battery in
storage port