Tait Limited TMAD1A Benutzerhandbuch

14 Basic Operation

The scan function is used to monitor a programmed 
group of channels, looking for activity. When activity is 
detected on one of the scan group channels, the radio 
stops on that channel. The amber LED flashes and, if the 
channel signalling is valid, the radio unmutes and you 
can hear the call.

Scanning resumes when the channel is no longer busy or 
the signalling is no longer valid.

1. Place the microphone on the microphone clip.

Note: Your radio may be programmed to 
scan whenever the microphone is off the 
microphone clip.

2. Press the function key assigned to scanning. The 

amber LED glows to show that the radio is scanning.

3. Press the scanning function key again to cancel scan-

ning, and the amber LED no longer glows.

If a member channel of the scan group is busy for a long 
time and you do not wish to hear the conversation, you 
can temporarily delete it from the scan group by using 
the function key assigned to nuisance delete.

Alternatively, press and hold the scanning function key. 
When the scan group is next selected, the deleted chan-
nel is again part of the scan group.

One or two priority scan channels may be set. These 
channels are scanned more often than other channels 
and are scanned periodically when a non-priority channel 
is busy. Note that priority channels cannot be removed 
from the scan group using the nuisance delete function.