Control Chief Corporation FLYMT1-433 Benutzerhandbuch
User’s Guide
FlyMax Transmitter
The FlyMax transmitter is shipped from the factory fully configured and ready to use.
Install Batteries
Remove the battery door on the back of the transmitter. Install 2 AA alkaline batteries making
sure to match the polarity marking inside the battery compartment. Use two new alkaline
batteries; do not mix old and new batteries.
sure to match the polarity marking inside the battery compartment. Use two new alkaline
batteries; do not mix old and new batteries.
The transmitter is now ready to use. Depressing any button the transmitter will activate the corresponding
function on the receiver. The green indicator located between Throttle Up and Pitch Up button displays the
transmitter status.
function on the receiver. The green indicator located between Throttle Up and Pitch Up button displays the
transmitter status.
Indicator OFF
No buttons depressed transmitter off
Indicator FLASHING
Transmitter active
Indicator SOLID
Replace batteries
IMPORTANT NOTE:
This device has been certified to comply with FCC Part 15 rules. Changes or modifications not expressly
approved by Control Chief Corporation could void the end user’s authority to operate this equipment
This device has been certified to comply with FCC Part 15 rules. Changes or modifications not expressly
approved by Control Chief Corporation could void the end user’s authority to operate this equipment