Digital Monitoring Products Inc PC0163 Benutzerhandbuch

15

This section allows you to enter the information needed for Remote Command/Remote 

Programming operation. A description of the Remote Options follows:

This option allows you to enter a code of up to eight digits for use in verifying the 

authority of a receiver to perform a remote command/programming session. The 

receiver must give the correct key to the communicator before being allowed access. All

CellComSL Communicators are shipped from the factory with the Remote Key preset as

blank.
To enter a new Remote Key, press any Select key and enter any combination of up to 8

digits. The numbers you enter appear as asterisks. Press COMMAND.

Enter YES to enable the communicator to be disarmed remotely. Selecting NO disables

remote disarming.

This function allows you to select which reports the communicator sends to the receiver.

NO - No Opening/Closing Reports are sent.

YES - Sends Opening/Closing Reports for each programmed area.

This option allows you to specify whether the communicator sends zone restoral reports 

and when they will be sent.  

NO - Restoral reports are not sent by the communicator. 

YES - The communicator

 always sends zone restoral reports at the time the zone 

restores from an alarm or trouble condition. 

DISARM - The communicator sends zone restoral reports when a zone that has 

restored from an alarm or trouble is disarmed. Twenty-four hour zones send restorals 

immediately.

This section allows you to select system wide parameters used in the operation of the 

communicator system. A description of each System Option follows:

Enter the entry delay time for all exit type zones programmed. When an armed Exit type

zone is faulted, the area must be disarmed before the entry delay expires or a fault will 

be detected. All Burglary type zones are delayed along with the Exit zone. Entry delay

times can be from 30 to 250 seconds. Default is 30 seconds.

Enter the Exit Delay time for all Exit type zones. When the exit delay time starts, all

activity on exit and burglary zones is ig nored until the exit delay expires. During Exit

Delay, if an exit zone trips, then restores, and trips again, the Exit Delay timer restarts.

This restart can occur only once. Exit delay times can be from 30 to 250 seconds.

Default is 60 seconds.

Exit Error Operation: At arming, when an entry/exit zone (EX) is faulted at the end of

the exit delay then a zone alarm and an Exit Error are sent to the receiver.

Enter the time allowed between zone faults. When a zone programmed for cross zoning

faults, the communicator begins counting down the Cross-Zone Time entered here. If the

same zone or another cross-zoned zone faults within this time, an alarm report is sent to 

the receiver.

If the Cross-Zone Time expires without the second zone fault, only a zone fault report

from the first zone is sent to the receiver. The Cross-Zone Time can be from 4 to 250

seconds in one second increments. Enter 0 (zero) to disable the Cross-Zone Time

feature. See the Appendix - Cross Zoning.

REMOTE OPTIONS

RMT KEY:

DISARM  NO  YES

SYSTEM REPORTS

O/C RPTS 

NO  YES

RESTORAL  

 

NO  YES     DISARM

SYSTEM OPTIONS

ENTRY DLY 1:   

EXIT DELAY:   

CRS ZONE TM:  

0