Digital Monitoring Products Inc PC0166 Benutzerhandbuch

The 1137 Emergency Light is a battery powered, wireless LED light 

activated by a loss of AC power output from your panel and may be 

used as a stair or path light. The 1137 operates using the supplied 3.0 

Vdc Lithium batteries.

All DMP 1100 Series Wireless Receivers and Panels

The 1137 Emergency Light includes the following:

• One 1137 Emergency Light
• Two 3.0 Vdc Lithium batteries
• Serial number label

For your convenience, an additional pre-printed serial number label 

is included. Prior to installing the light, record the serial number or 

place the pre-printed serial number label on the 1137 base (see Figure 

3). This number is required during programming. As needed, use the 

zone name and number label to identify a specific Emergency Light.

Refer to the panel programming guide as needed. Program the device as an AC Power Trouble Output in ZONE 

INFORMATION during panel programming. At the Serial Number prompt, enter the eight-digit serial number. Continue 

to program the zone as directed in the panel programming guide.

The 1137 Emergency Light provides a survey capability to allow one person to confirm communication with the 

receiver. The 1137 Emergency Light Status LED turns on whenever data is sent to the receiver then immediately 

turns off when the receiver acknowledgement is received.
Pressing the button sends data to the receiver to confirm operation. When the Emergency Light does not receive 

an acknowledgement from the receiver the LED remains on for approximately eight seconds to indicate that 

communication is not established. Communication is also faulty when the LED flashes multiple times in quick 

succession. Relocate the light or receiver until the LED immediately turns off indicating the light and receiver are 

communicating properly. Proper communication between the light and receiver is verified when for each press of the 

button, the LED blinks immediately on and immediately off. Repeat this test to confirm five separate consecutive 

LED blinks. Any indication otherwise means proper communication has not been established.

SERIAL #