Digital Monitoring Products Inc PC0198 Benutzerhandbuch

1

The 1158 can be programmed with up to eight zones. When 

programming the 1158 in the panel, refer to the panel 

programming guide as needed.
Program the serial number associated with contacts 1 

through 4 first. Then, be sure to start by programming 

contact 1.
When you enter the serial number associated with contacts 

5 through 8, contact 1 displays again indicating that you are 

programming the first contact associated with that serial 

number.

1.  In 

ZONE INFORMATION, enter the ZONE number, and 

then press 

CMD.

2.  Enter the 

ZONE NAME and press CMD.

3.  Once 

ZONE TYPE appears, select the appropriate 

zone type, and then press 

CMD.

4.  At the 

NEXT ZONE prompt, select NO. If you see the 

WIRELESS ZONE prompt, select YES.

Note: If you are programming the 1158 onto a 

zone that can be either hard wired or wireless, 

then this prompt appears. If the zone you are 

programming is wireless-only, then the prompt 

does not appear.

5.  Enter the eight-digit 

SERIAL NUMBER and press CMD.

6.  Enter the 

CONTACT number being used. 

7.  Enter the 

SUPERVSN TIME and press CMD.

8.  At the 

NEXT ZONE prompt, select YES and continue 

to program up to seven more zones.

Note: Zones must be entered sequentially. For 

example, if you begin by programming zone 71, 

you would need to program zone 72 as the next 

contact.

When a wireless receiver is installed, a receiver is restarted, 

the panel is reset, or if programming is complete, then the 

supervision time is reset. 
If the receiver has been powered down for more than one 

hour, then the 1158 may take up to an additional hour to send 

a supervision message. 
A missing message may display on the keypad until the 

supervision message is sent.

When a DMP panel is installed in a 

location with an existing non-DMP 

panel, the 1158 Wireless Eight-Zone 

Takeover Module can be used to 

convert up to eight existing normally 

closed, hardwired zones into wireless 

zones. This allows the new DMP 

panel to communicate with existing 

zones.

The 1158 uses two serial numbers to 

accommodate up to eight zones and 

can be powered by transferring AC 

and battery power from the existing 

panel. 

All DMP 1100 Series Wireless 

Receivers and burglary 

panels. See the last page for 

compatibility details.

•  1158 Wireless Eight-Zone 

Takeover Module

•  Hardware pack