Quantum Instruments FW7Q Benutzerhandbuch

4. Setting the Zone Code

The FreeXwire FW7Q has no Zone Code Switch. When used with a Qflash 4d, FW7Q will
activate for any Zone 1, 2, 3, or 4, on the matching Channel. However, Qflash 5d can set

the Zone Code of FW7Q through its control panel. (Note: Qflash 4d models can be

upgraded to Qflash 5d models. Please contact the Service Department @ Quantum).

To set the Zone on a Qflash 5d, press the Option button three times. The Zone Code

settings should display on Qflash screen.

Use the Set button select a Zone, then press the

Up S and Down T buttons to turn the selected Zone on or off.

5. Qflash T4 Remote Control Operation

The Remote mode allows a “Control” Qflash to remotely set the functions of “Remote”

Qflash units linked by the FreeXwire system. A full explanation of the Wireless Control mode

appears in the Qflash manual under Multiple Qflash Operation - Wireless Mode.

Set Qflash 4d/5d to Remote Mode by pressing the Mode button. You can select to set

Qflash as Remote 1 or Remote 2. If you have two remote units, set one unit for Remote 1

and the other unit for Remote 2. Now the “Control” Qflash (which is connected to an FW9T

or FW10) controls the operating mode and settings of Remote unit(s). See Qflash

instructions for details.

6. Digital Wireless TTL Operation

Set Qflash 5d to Remote Mode as describe in Section 5. The Remote unit will receive digital

wireless TTL signal from Control unit. No further setting is required. This mode is
compatible with digital camera pre-flash TTL, as well as film camera TTL exposure control.

Qflash 4d units need to be upgraded to Qflash 5d models for this function.

7. Range selection

The range of FW7Q receiver is set to NORMAL by default which provides a range up to 200’

(70m). This setting is recommended for general needs and for digital wireless. If the

operation range is more than 200’ (usually for wireless shutter, up to 500’), set RANGE to

HI. This can be set via the Qflash 5d “Options”. If using a Qflash 4d, the range setting will

be NORMAL only.

8. Specifications

Size:

3 X 1.5 X 1 in (8 x 3.5 x 2.5 cm)

Weight:

1.3

(37g)

Maximum Range:

varies with local conditions – up to 400’ (120m) with FW10

or up to 500’(150m) with FW9

Maximum flash rate:

25fps