ademco 8DL6CO Benutzerhandbuch
SiXCO
Wireless Carbon Monoxide (CO) Detector/ Wireless Carbon Monoxide (CO) Detector
Installation Instructions
Instructions d’installation
This device is intended for use with Honeywell control
panels that support SiX series devices. Before installing
detectors, please thoroughly read these installation
instructions.
panels that support SiX series devices. Before installing
detectors, please thoroughly read these installation
instructions.
This device is intended for use with Honeywell
control panels that support SiX series devices.
Before installing detectors, please thoroughly read
these installation instructions.
control panels that support SiX series devices.
Before installing detectors, please thoroughly read
these installation instructions.
Features
Features
• 10-year life
• CO Detector End-of-Life reporting (detector needs
replacing)
• Carbon Monoxide detector maintenance reporting
• Low Battery Detection
• Multi-color status LED
• Low Battery Detection
• Multi-color status LED
• 10-year life
• CO Detector End-of-Life reporting
• Carbon Monoxide detector maintenance reporting
• Low Battery Detection
• Multi-color status LED
• CO Detector End-of-Life reporting
• Carbon Monoxide detector maintenance reporting
• Low Battery Detection
• Multi-color status LED
POWER UP
•
Remove battery pull tab. Be sure
batteries are seated properly to
avoid a low battery condition
after 15 seconds.
•
Upon power up, Green LED
Blinks every 2 secs / Sounder is
Silent.
POWER UP
•
Remove battery pull tab. Be
sure batteries are seated
properly to avoid a low
battery condition after 15
seconds.
•
Upon power up, Green LED
Blinks every 2 secs /
Sounder is Silent.
ENROLLMENT
ENRÔLEMENT
This device can be enrolled and programmed either
before or after installation.
1.
Set the Lyric Controller in Programming Mode and go to
Zone Programming. Select Add New and then Serial
Number.
2.
Remove the battery tabs to activate the device and begin
the enrollment process.
3.
The Green LED flashes rapidly during enrollment (up to
about 20 seconds).
*NOTE: Enrollment time varies depending on the signal
*NOTE: Enrollment time varies depending on the signal
strength between the device and the controller.
• The detector sends its unique MAC ID (Serial Number)
and Services information to the controller.
• The controller registers the device and displays the
transmitter data on screen.
4.
Enrollment is confirmed when the Green LED is ON for 3
seconds and the detector chirps.
5.
Press SAVE.
Le dispositif peut être enrôlé et programmé avant
ou après l'installation.
1. Réglez le contrôleur Lyric en mode de
1. Réglez le contrôleur Lyric en mode de
programmation et accédez à la programmation
des zones. Sélectionnez Add New (ajouter
nouveau) et ensuite Serial Number (numéro de
série).
2. Retirez la languette qui recouvre la pile pour
activer le dispositif et commencer la procédure
d'enrôlement.
3. La DEL verte clignote durant l'enrôlement
(pendant jusqu'à environ 20 secondes*).
NOTE: La durée de l'enrôlement varie selon la
NOTE: La durée de l'enrôlement varie selon la
puissance du signal entre le dispositif et
le contrôleur.
• Le dispositif transmet au contrôleur son ID
MAC (numéro de série) et l'information pour les
services.
• Le contrôleur enregistre le dispositif et affiche
les données du transmetteur sur l'écran.