Rhine Electronics Co Ltd 7212T Benutzerhandbuch
1/1 2009/2/4
INSTRUCTIONS FOR OPERATION
SETING THE OPERATING CONTROLS
1.This unit operates on AAA 1.5 volts battery*2 (not included).
To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .
2. Store the controller away from excess heat or humidity .
3. This remote control unit is required with 32 code combinations. To prevent
To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .
2. Store the controller away from excess heat or humidity .
3. This remote control unit is required with 32 code combinations. To prevent
possible interference from or to other remote units such as garage door
openers, car alarm or security system . If you find that your fan and light
kit go on and off without using your control , simply change the combination
code in your transmitter and receiver .
openers, car alarm or security system . If you find that your fan and light
kit go on and off without using your control , simply change the combination
code in your transmitter and receiver .
4.Operation buttons on the panel of transmitter .
key – For fan speed up
key – For fan speed down
key – For fan speed down
OFF key – For fan speed off .
REV key – For fan speed Reverse .
REV key – For fan speed Reverse .
key – For upper light brightness and ON/OFF control .
key – For bottom light brightness and ON/OFF control .
5.Start the fan :
Press the selected speed button to run the fan at the desired .
By press the speed up-down button to select the needed speed, and
though the LED light to see the fan speed.
By press the speed up-down button to select the needed speed, and
though the LED light to see the fan speed.
6.Turn off the fan :
Press the OFF button .
7.Light control :
Turn the light on or off by only touching the LIGHT CONTROL button .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .
One of the important feature of this control is AUTO-RESUME . After power
on , it allows the light return to where it was off .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .
One of the important feature of this control is AUTO-RESUME . After power
on , it allows the light return to where it was off .