Axcera 79XITS-7037 Benutzerhandbuch

ADC Telecommunications certifies that upon leaving our facility, your equipment was undamaged and in
proper working order. Please inspect all material upon arrival for any sign of damage. The shipping
container should be examined for obvious damage indicative of rough handling. Remove the translator and
all other material from the shipping container and check for damage: dents, large scratches, or broken
connectors etc. Open the translator and remove all packing material from inside the unit and inspect for
damage. Any claims against in-transit damage should be directed to the Carrier.

Since the 6457A is tray based, it must be mounted in a 19" equipment rack. This cabinet must be housed in
an environmentally controlled cabinet or building. It is also very important to verify that adequate AC power
is available.

Complete the following for equipment installation:

If the unit is supplied with a cabinet, carefully remove the cabinet from the shipping container. If the
translator tray has been shipped separately, the internal shipping material must be removed from inside the
cabinet before the tray is installed. Cut and remove the cable ties or cords which hold the tray harness
breakouts to the tray slides. Carefully remove the foam packing material from around the cables, connectors
and slides. Do not use a knife or other sharp object, as these may cut into the harness wires.  Once the
cabinet has been properly positioned, the trays can now be installed.

Extend the cabinet mounted slide rails out to their full and locked position. Place the tray with the slides into
the cabinet slide rails until the tray locks into place. Press the side lock tabs on the rails to unlock the tray
and carefully move the tray completely into the rack.  Check that the cable breakouts in the rear are not
caught on the tray as the tray is slid into place.

If the trays were shipped mounted in the cabinet, a front and rear shipping bracket must be removed in order
to allow the trays to be pulled out.

If the tray does not slide in and out of the cabinet smoothly, loosen the hardware holding the slides in place.
Move the tray accordingly and tighten the hardware again. Repeat if necessary until the tray slides in and
out freely.

Next, secure the small cable retractors (attached to the main harness) to the back of the tray by sliding them
into the clip located between the AC hook up and the fan on the back of the tray.

Connect the wires to the back of the tray. Each wire is marked with a number corresponding to the location
where it should be connected to the back of the tray.