GoPro WIFIRC-001 Benutzerhandbuch

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the 

FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential 

installation.  This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio communications.  However, there is no 

guarantee that interference will not occur in a particular installation.   If this equipment does cause harmful interference to 

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to 

correct the interference by one or more of the following measures: 

 

Reorient or relocate the receiving antenna. 

 

Increase the separation between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

 

Consult the dealer or an experienced radio/TV technician for help. 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device 

may not cause harmful interference, and (2) this device must accept any interference received, including interference that 

may cause undesired operation. 

 

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's 

authority to operate this equipment. 

 

For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not 

possible. 

 

This EUT is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and had 

been tested in accordance with the measurement methods and procedures specified in OET Bulletin 65 Supplement C.

 

 

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two 

conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including 

interference that may cause undesired operation of the device. 

 

This EUT is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and had 

been tested in accordance with the measurement methods and procedures specified in OET Bulletin 65 Supplement C. 

This equipment should be installed and operated with minimum distance 1cm between the radiator & your body. 

 

For body worn operation, this WIFI Remote has been tested and meets FCC RF exposure guidelines when used with an 

accessory that contains no metal and that positions the handset a minimum of 1cm from the body. Use of other accessories 

may not ensure compliance with FCC RF exposure guidelines.