Nikko Co Ltd TP6793H Benutzerhandbuch

Seite von 7
English
2
English
3 language
Pass the antenna wire through the antenna tube, then insert the tube into the antenna tube holder.
If the antenna tube cannot be successfully inserted into the antenna tube holder, try holding the root of the 
antenna wire with fingers of one hand and extending the wire with fingers of the other hand.
* Note: Be careful not to pull antenna wire too strong.
1. HOW TO ATTACH ANTENNA TUBE
Antenna wire
Antenna tube
Antenna tube
 holder
BEFORE YOU START
Do not charge Battery Pack immediately after use. Wait until it has cooled before charging.
Avoid short circuits. Short circuits will cause overheating, burning of the cords and other damages to the 
battery Pack and Charger.
The Ni-Cd Battery Charger should be used for charging one Battery Pack. Do not use the Charger for 
charging other type of batteries and battery packs
Do not use the Charger as a direct current outlet for other electrical appliances or machines.
Make sure that the Battery Pack and Charger are kept out of the hands of infants and small children while 
charging.
Do not charge near fires, where the temperature is extremely high, or where it is wet or damp.
The charger will become slightly heated while charging. Allow sufficient free space around the Charger.
If the power of the battery pack is weak in spite of proper charging, the batteries may be worn out from 
repeated use. Replace it with a new Ni-Cd battery pack.
Dispose of use Ni-Cd battery packs correctly.
Disconnect the supply before making or breaking connections to the battery.
Only use batteries or accumulators of the recommended type or a similar type.
WARNING AGAINST RECHARGING NON-RECHARGEABLE BATTERIES.
Please use this battery charger only for the charge of the rechargeable battery pack.
The Ni-Cd battery pack should be charged under the supervision of an adult.
CAUTION
RECHARGING
"WARNING! USE UNDER THE DIRECT SUPERVISION OF AN ADULT."
*   The newly purchased Ni-Cd pack is not charged. Charge before operating.
Household 
outlet
Ni-Cd battery pack 
OR
Charger
Household 
outlet
Charger
Ni-Cd battery pack 
1. Join the connector of the charger to the connector of 
the Ni-Cd battery pack.
2. Plug the charger into an electrical outlet.
3. Recharge for about 4-5 hours.
4. When the recharging is over, plug out the charger 
from the electrical outlet and detach the connectors.
When playing for the first time after purchase, or after a long 
interval, the battery power may be weak. Even after recharging, 
the playing time can be relatively short. The battery will gradually 
regain power after 2 or 3 repetitions of usage and recharging.
KMNA-1/1040820-R
KMNA-1/1040820-R1