Tecom Co Ltd USC9330BI Benutzerhandbuch

 

www.cisco.com
Cisco has more than 200 offices worldwide. Addresses, phone numbers, and fax numbers are listed on the 

Cisco website at www.cisco.com/go/offices.

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, 
go to this URL: 

. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does 

not imply a partnership relationship between Cisco and any other company. (1110R)

© <year> Cisco Systems, Inc. All rights reserved. 

Printed in the USA on recycled paper containing 10% postconsumer waste.

78-xxxxx-xx

Refer to the USC 9330 Installation Guide online for information 
regarding the optimal placement of your USC 9330 small cell.

Follow these instructions to connect your USC 9330 for use:

Screw the two antennas into the antenna ports on the top of the 
small cell: Ant1 port=3G antenna, Ant2 port=2G antenna.

Seal the antenna ports with waterproof glue or tape to prevent 
any moisture from penetrating.

Mount the USC 9330 small cell on a wall, ceiling or pipe as 
described in the USC 9330 Installation Guide: 

 

If you are using the DC power option:

Remove the connector cap from the DC power connector.

Connect the DC cable to the DC power connector on the 
USC 9330.

For warranty information, refer to: 

http://www.cisco-servicefinder.com/WarrantyFinder.aspx

Translated versions of the following safety warnings are provided in Cisco USC  9330 
Regulatory Compliance and Safety Information, located on Cisco.com.

 

 

This warning symbol means danger. You are in a situation that could 
cause bodily injury. Before you work on any equipment, be aware of the 
hazards involved with electrical circuitry and be familiar with standard 
practices for preventing accidents. Use the statement number provided 
at the end of each warning to locate its translation in the translated 
safety warnings that accompanied this device. Statement 1071

 

 

Read the installation instructions before you connect the system to its 
power source. Statement 1004

Installation of the equipment must comply with local and national 
electrical codes. Statement 1074

In order to comply with FCC radio frequency (RF) exposure limits, 
antennas should be located at a minimum of 7.9 inches (20 cm) or more 
from the body of all persons. Statement 332

Use only with listed ITE equipment.