Tecom Co Ltd WL503X Benutzerhandbuch

 

9

6. Make both APs working on the same channel, then you 

should have an wireless bridge working now. 

1. 

Like in “Point-to-Point” mode, just clicks on 

“Point-to-MultiPoint”, do the same step to all AP you want 

to work in bridge mode. 

2.  Make sure that all bridge mode AP on the same channel. 

Then you can connect with each other. 

 

If you want to allow only AP with authentication to connect, 

then you can start up authorization algorithm. 

1.  Make an authorized MAC list---just put all the MAC address 

of AP you want to connect in a text file. For example, if you 

want AP which MAC address is 00-00-22-22-22-50 in your 

MAC list, then you just put “000022222250” in your list file. 

2. Run “AP Configuration”. Clicks on “Setup” 

”Wireless 

LAN” 

”Authorized Mac Addresses”, you will see a 

pop-up dialog box as below, except the content is blank.