Lectrosonics Inc SSMA1 Benutzerhandbuch

9

Setup Screens

DOWN Button Menu

Hold the DOWN button while powering up the unit. Then press the AUDIO button repeatedly to scroll through the 

following settings. Use the UP and DOWN arrows to select the available options under each setting.

•

rc - remote control operation; selections: on, oFF

•

PbAc - power-back-on after power loss; selections: 0 (stay turned off), 1 (turn back on)

•

bL - back light duration; selections: 5 (minutes), 30 (seconds), on (always on)

UP Button Menu

Hold the UP button while powering up the unit. Then press the AUDIO button repeatedly to scroll through and se-

lect the following settings (bulleted). Use the UP and DOWN arrows to select the available options under each setting.

•

CP - compatibility mode; press the UP and DOWN arrows to select one of the following:

 

  CP 400 

400 Series (Digital Hybrid) mode

 

  CP 3 

Mode 3 (contact the factory for details)

 

  CP 200 

200 Series mode; receivers such as UCR200/201/205D/210/211

 

  CP 100 

100 Series mode; UCR100 receiver

 

  CP 7 

Mode 7 (contact the factory for details)

 

  CP 6 

Mode 6 (contact the factory for details)

 

  CP IFb 

IFB Series mode; IFBR1/1a receivers

•

Pr - RF power output; selections: 25, 50

•

In - Input configuration; press the UP and DOWN arrows to select one of the following:

 

  In dYn 

no bias, lo-Z; use for dynamic microphones

 

  In CoS 

4v bias, lo-Z; phase reversed; use for Sanken COS-11, M152 and similar mics

 

  In b6 

2v bias, lo-Z; use for Countryman B6 and similar mics

 

  In dPA 

4v bias, mid-Z; use for DPA lavaliere and similar mics

 

  In L In 

no bias, hi-Z; use for line level input

 

  In otH 

4v bias, lo-Z; same as CoS but audio phase is not reversed; for various mics

 

  In SEt 

Press the AUDIO button for manual setup of input for explicit control over bias voltage, input 

   

resistance and audio polarity. Press the AUDIO button to select the following 

   

parameters, then use the UP and DOWN arrows for each item to set the values.

 

 

bIAS - bias voltage on the input; selections 

0, 2 or 4

 

 

rES - input impedance; selections: 

0 (300 ohms), Lo (approx. 4 k ohms) or HI (approx. 100 k ohms)

 

 

AP - audio polarity (aka “phase”); selections: 

P for positive, n for negative (reversed)

  

NOTE: When you press AUDIO after setting the polarity, the screen will leave this submenu and return 

to the 

In menu. To return to this submenu, press AUDIO repeatedly and scroll through the list again.

 

  StP 

Frequency tuning step size in kHz; selections: 25 kHz or 100 kHz