Lectrosonics Inc SSMB1 Benutzerhandbuch

11

IR (infrared) Sync

An IR (infrared) link between an associated receiver 

and the transmitter can be used to shorten setup time 

and ensure that the correct settings in the transmitter 

are made. The dome on the side panel of the transmit-

ter is the port used for the IR link. The receiver is nor-

mally used to identify a clear operating frequency. Once 

step size, frequency and compatibility mode are set in 

the receiver, the settings can be sent to the transmitter 

via this IR link.

Place the transmitter close to the IR enabled receiver 

with the ports facing each other within a foot or two 

apart. Send the settings with the trigger on the receiver. 

If the settings are successfully transferred, a confirma-

tion message will appear on the transmitter LCD.

NOTE: If a mismatch exists between the receiver 

and transmitter, an error message will appear on 

the transmitter LCD stating what the problem is.

Removable Belt Clip

The belt clip may be removed by rotating it as shown 

and sliding it off the retaining tabs on the battery door.

When mounting the belt clip onto the battery door, care-

fully align the openings with the retaining tabs on the 

door. If they are not precisely aligned, the door may not 

close and latch properly.