Lectrosonics Inc SSMB2 Benutzerhandbuch
Micro Body Pack Transmitter
Rio Rancho, NM
9
Setup Steps
The setup menus are accessed by holding either the
UP or DOWN arrow while powering the unit on. Refer
to Setup Screens on the next page for details of each
setup parameter.
UP or DOWN arrow while powering the unit on. Refer
to Setup Screens on the next page for details of each
setup parameter.
The following list outlines the steps necessary to set up
the transmitter for normal use.
the transmitter for normal use.
1) Install a charged battery.
2) Set the compatibility mode to match the receiver to be
used.
3) Adjust the step size and frequency to match the re-
ceiver. The frequency is normally determined using
the receiver to identify one within clear operating
spectrum. Refer to the receiver instructions for de-
tails on using features such as scanning.
the receiver to identify one within clear operating
spectrum. Refer to the receiver instructions for de-
tails on using features such as scanning.
NOTE: Some Lectrosonics receivers include an
IR (infrared) port to transfer settings from the
receiver to the transmitter. Refer to the section on
IR (infrared) Sync for details.
IR (infrared) port to transfer settings from the
receiver to the transmitter. Refer to the section on
IR (infrared) Sync for details.
4) Connect the microphone or audio source to be used.
Select the correct input configuration.
5) Adjust the input gain. Refer to Adjusting the Input
Gain on the following page for details.
6) Turn on the receiver and verify that solid RF and audio
signals are present (see receiver manual)