3M Company SSDPV30 Benutzerhandbuch
Travel Document Reader User Guide
DRAFT
3M Confidential
© 3M 2006 All rights reserved.
DT-01715C
6
Document Window
The document window is a glass surface located on top of the reader. Place documents on the
window to scan them. Keep this surface clean to ensure optimum operation of the reader.
window to scan them. Keep this surface clean to ensure optimum operation of the reader.
See Cleaning on page 19 for more information.
Indicator LEDs
The LEDs indicate the reader status and the result of scanning a document.
Table 1: Indicator LED
Ready (green)
The reader is ready to scan a document (when connected to the host
application).
application).
Busy (amber)
The reader is scanning a document and processing the data.
OK (green)
A known document type was presented and processing was
successful.
successful.
Error (red)
The document is of an unknown type or did not process properly.
Back Panel
The back panel features the power switch, power supply connector and USB communication
ports. Data is sent to the host PC through the USB 2.0 host connector.
A built-in USB hub and two auxilliary USB 2.0 connectors allow you to connect additional USB
peripherals for example, mouse/keyboard, 2-D barcode readerpowered from the reader. In
addition, a security loop can be used to tether the reader to the workplace.
ports. Data is sent to the host PC through the USB 2.0 host connector.
A built-in USB hub and two auxilliary USB 2.0 connectors allow you to connect additional USB
peripherals for example, mouse/keyboard, 2-D barcode readerpowered from the reader. In
addition, a security loop can be used to tether the reader to the workplace.
Figure 8: Back Panel Ports
USB 2.0 host
port
Power
connector
Auxiliiary USB 2.0 ports
Setting up the Reader
Before beginning to read documents, you must
•
verify your host PC’s capabilities
•
unpack the reader
•
install the software
•
connect the power supply