3M Company SSDPV30 Benutzerhandbuch

Travel Document Reader User Guide

DRAFT

3M Confidential

DT-01715C

Connecting to a Host System

The reader is supplied with a USB communication cable.

1. Insert the USB connector of the supplied cable into a USB port on the host system.

2. Insert the USB connector of the supplied cable into the USB port, located on the back

panel of the reader.

Note:

The ends of the USB cable are keyed (square for the reader and rectangular for
the PC) for easy identification.

Connecting the Power Supply

1. Connect the DIN connector from the power supply to the power connector at the rear of

the reader.

Note:

There is only one orientation that will allow the DIN cable to be connected to
the shielded power port.

2. Connect the AC cable to a functioning power outlet.

3. Turn on the power switch.

Installing the USB Driver

If the reader is detected as a new USB device, you must install the USB drivers.

Note:

This procedure is based on Windows® 2000 SP4, but the Windows® XP operating
system is similar.

1. In the Upgrade Device Driver Wizard, select Display a list of the known drivers for

this device so that I can choose a specific driver

and click Next.

2. Click Have Disk.

The Install From Disk window opens.

3. Click Browse and locate the SW00296x.INF file that was provided with the reader.

Note:

The USB driver was written to folder “3M document authenticator” during
software installation.

4. Select the file, and click Open.

5. Click OK.

A list of models appears.

6. Select 3M Full Page Reader with USB2 and click Next.

A warning appears, stating that the driver is not signed by Microsoft. Click Yes to
continue.

7. Click Next to install the driver.

8. When the driver finishes installing click Finish.