Mindray DS USA Inc. VT0190-00000 Benutzerhandbuch
Cable repeater setup:
The cable repeater is configured in two steps. The first is to adjust the gain on each
antenna. The second is to adjust the gain between the repeater and the TIM.
Step 1-
The cable repeater is configured in two steps. The first is to adjust the gain on each
antenna. The second is to adjust the gain between the repeater and the TIM.
Step 1-
1.1 Remove jumper J3 in the “A” leg 0670-00-0776-01 board. This will activate the
RF tap that is the SMA connector on the 0670-00-0776-01 PCB.
1.2 Using the SMA to SMA cable attach one end to the 0670-00-0776-01 PCB. With
a programmed test telepak attach the second SMA to SMA connector to the
telepak with the 30dB attunuator in series at the telepak. Attach the other end to
the spectrum analyzer using a SMA to N adapter.
telepak with the 30dB attunuator in series at the telepak. Attach the other end to
the spectrum analyzer using a SMA to N adapter.
1.3 Set the analyzer to span the correct frequency and measure the peak amplitude.
Record this value.
1.4 Detach the cable from the spectrum analyzer at the adapter. Attach the cable from
the 0670-00-0776-01 PCB to the analyzer.
1.5 Attach the telepak with the cable and attenuator to an antenna on the repeater leg
that is on the “A” leg. Adjust the antenna gain such that the spectrum analyzer
peak measurement for the frequency is the recorded value minus 1 to 2 dB.
Repeat for all antennas on the “A” leg.
peak measurement for the frequency is the recorded value minus 1 to 2 dB.
Repeat for all antennas on the “A” leg.
1.6 Install the removed jumper to J3. Detach the SMA cable at the 0670-00-0776-01
board.
1.7 Remove jumper J3 in the “B” leg 0670-00-0776-01 board. This will activate the
RF tap that is the SMA connector on the 0670-00-0776-01 PCB.
1.8 Attach the SMA cable from the analyzer to the 0670-00-0776-01 PCB .
1.9 Attach the telepak with the cable and attenuator to an antenna on the repeater leg
1.9 Attach the telepak with the cable and attenuator to an antenna on the repeater leg
that is on the “B” leg. Adjust the antenna gain such that the spectrum analyzer
peak measurement for the frequency is the recorded value minus 1 to 2 dB.
Repeat for all antennas on the “A” leg.
peak measurement for the frequency is the recorded value minus 1 to 2 dB.
Repeat for all antennas on the “A” leg.
1.10 Install the removed jumper to J3. Detach the SMA cable at the 0670-00-0776-01
board.
This completes the antenna setup.
Step 2-
Step 2-
2.1 Remove the BNC connection of the antenna network from “A” leg on the TIM.
2.2 With the server running WMTS.EXE and displaying the detailed RF list screen,
2.2 With the server running WMTS.EXE and displaying the detailed RF list screen,
attach the telepak to the TIM using the 30dB attenuator and the SMA to BNC
cable. Record the RSSI displayed for the channel that the telepak was assigned.
cable. Record the RSSI displayed for the channel that the telepak was assigned.