Keystone Heddolf International ARC318 Benutzerhandbuch
INSTRUCTIONS FOR TRIPLE ENTRY TRANSMITTER
Garage Door & Gate Openers
Read the following instructions thoroughly before using the remote.
Programming Remote Controller to the Opener
1. Remove the Transmitter Cover
Remove the access cover from the front of the transmitter by
sliding the cover away from the top of the transmitter (Figure A).
This will expose the battery and the dip switches. The code can
now be changed using a small screwdriver.
sliding the cover away from the top of the transmitter (Figure A).
This will expose the battery and the dip switches. The code can
now be changed using a small screwdriver.
2. Setting the codes
There are eight (8) dip switches, each of which can be placed in
three different positions (+, 0, -). DO NOT set all switches in the
same position, such as all +, all -, or all zero (Figure B).
WARNING: No other adjustments should be made inside the
transmitter.
Made note of the button you chose, as this will be the button you
must now use to operate your gate.
To activate, simply depress your transmitter button until the gate
begins to move.
If you have more than one gate operator, repeat #3, Commit the
code to Memory in Control Board as needed. Be sure to select a
different transmitter button to use with each operator.
three different positions (+, 0, -). DO NOT set all switches in the
same position, such as all +, all -, or all zero (Figure B).
WARNING: No other adjustments should be made inside the
transmitter.
Made note of the button you chose, as this will be the button you
must now use to operate your gate.
To activate, simply depress your transmitter button until the gate
begins to move.
If you have more than one gate operator, repeat #3, Commit the
code to Memory in Control Board as needed. Be sure to select a
different transmitter button to use with each operator.
Warning
To avoid possible serious injury or death from a garage door or moving gate:
-Keep all remote controls out of children’s reach at all times. Never allow children near
batteries!
-Only activate door or gate when it is in clear view and is in proper working condition.
-Always completely monitor garage door and gate opener until completely opened or
closed.
-Never allow anyone to cross area of opening and closing of moving garage door or gate.
-Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
FCC Regulations: This device complies with FCC Rules Part 15. Operation is subject to
following two conditions: 1) This device may not cause harmful interference. 2) This device
must accept an interference that may cause an undesired operation. Transmitter distance
may vary due to circumstance beyond our control.
Copyright@ Keystone/Heddolf Remotes 2013
Slider the cover for
battery replacement
Battery Type: 23A
battery replacement
Battery Type: 23A
Figure A
Figure B