Keystone Heddolf International M220300 Benutzerhandbuch

Seite von 1
INSTRUCTIONS FOR Radio Control Operator 
Single entry transmitter, Mini Transmitter,   
 
Read the following instructions thoroughly before using the remote. 
This transmitter must be adjusted so that the coding switches match the coding on your present operating 
transmitters or receiver   
 
FCC Regulations: This device complies with FCC Rules Part 15.  
Operation is subject to following two conditions: 1) This device may not 
cause harmful interference.    2) This device must accept an interference that 
may cause an undesired operation.    Transmitter distance may vary due to 
circumstance beyond our control. 
 
Programming Remote Controller to the Opener 
1.  Remove the Transmitter Cover 
Remove the access cover from the front of the transmitter by sliding the 
cover away from the top of the transmitter (Figure A). This will expose the 
battery and the dip switches. The code can now be changed using a small 
screwdriver. 
2.  Setting the codes 
You may set your transmitter to any code you desire, but be sure the code 
you set matches both your transmitter and receiver.   
There are ten (10) dip switches, each of which can be placed in two 
different positions (+,-). DO NOT set all switches in the same position, such 
as all +, all -, (Figure B). WARNING: No other adjustments should be made 
inside the transmitter. 
Warning
 
To avoid possible serious injury or death from a garage door or moving gate: 
-Keep all remote controls out of children’s reach at all times. Never allow children near batteries!   
-Only activate door or gate when it is in clear view and is in proper working condition.     
-Always completely monitor garage door and gate opener until completely opened or closed. 
-Never allow anyone to cross area of opening and closing of moving garage door or gate.     
-Changes or modifications to this unit not expressly approved by the party responsible for compliance 
could void the user’s authority to operate this equipment. 
 
Copyright@ Keystone/Heddolf Remotes 2014 
 
 
Slider the cover for battery 
replacement 
Battery Type: 23A 
Figure A 
Figure B