Uniden America Corporation UP683 Benutzerhandbuch
Model: D100 DECT NA
Model: D100 DECT Repeater NA
Model: D160 DECT Handset NA
July 2012 - Avaya
IMPORTANT NOTICE
Read all safety, installation, and user
documentation prior to installing or operating
this product. To view and download safety,
installation, and user documentation go to:
documentation prior to installing or operating
this product. To view and download safety,
installation, and user documentation go to:
http://support.avaya.com
. All information is
subject to change without notice. Always check
Avaya’s Support web site for updates –
Avaya’s Support web site for updates –
http://support.avaya.com
.
Important Safety Instructions
When using your telephone equipment, basic
safety precautions should always be followed to
reduce the risk of fire, electric shock and injury
to persons, including the following:
safety precautions should always be followed to
reduce the risk of fire, electric shock and injury
to persons, including the following:
This unit is NOT waterproof. DO NOT expose
it to rain or moisture.
it to rain or moisture.
Do not use this product near water, for example,
near a bath tub, wash bowl, kitchen sink or
laundry tub, in a wet basement or near a
swimming pool.
near a bath tub, wash bowl, kitchen sink or
laundry tub, in a wet basement or near a
swimming pool.
Avoid using a telephone (other than a cordless
type) during an electrical storm. There may be a
remote risk of electric shock from lightning.
type) during an electrical storm. There may be a
remote risk of electric shock from lightning.
Do not use the telephone to report a gas leak in
the vicinity of the leak.
the vicinity of the leak.
Use only the power cord and batteries indicated
in the manual. Do not dispose of batteries in a
fire. They may explode. Check with local codes
for possible special disposal instructions.
in the manual. Do not dispose of batteries in a
fire. They may explode. Check with local codes
for possible special disposal instructions.
Do not place the handset in any charging cradle
without the battery installed and the battery
cover securely in place.
without the battery installed and the battery
cover securely in place.
SAVE THESE INSTRUCTIONS!
CAUTION! Risk of explosion if battery is
replaced by an incorrect type! Dispose of
used batteries according to the
instructions. Do not open or mutilate the
battery. Disconnect the battery before
shipping this product.
CAUTION! Risk of explosion if battery is
replaced by an incorrect type! Dispose of
used batteries according to the
instructions. Do not open or mutilate the
battery. Disconnect the battery before
shipping this product.
Rechargeable Battery Warning
If your equipment contains a rechargeable
Nickel-Metal-Hydride (Ni-MH) battery;
Nickel is a chemical known to the state of
California to cause cancer.
Do not short-circuit the battery.
The batteries in this equipment may explode if
The batteries in this equipment may explode if
disposed of in a fire.
Do not charge the batteries in any charger other
than the one specified in the owner's manual.
Using another charger may damage the
battery or cause it to explode.
Using another charger may damage the
battery or cause it to explode.
As part of our commitment to protecting our
environment and conserving natural resources,
Uniden voluntarily participates in an RBRC®
industry program to collect and recycle used Ni-
MH batteries within the United States. Please
call 1-800-8-BATTERY for
information on Ni-MH battery
recycling in your area.
(RBRC® is a registered
trademark of the
Rechargeable Battery
Recycling Corporation.)
environment and conserving natural resources,
Uniden voluntarily participates in an RBRC®
industry program to collect and recycle used Ni-
MH batteries within the United States. Please
call 1-800-8-BATTERY for
information on Ni-MH battery
recycling in your area.
(RBRC® is a registered
trademark of the
Rechargeable Battery
Recycling Corporation.)
Rechargeable batteries must be recycled
or disposed of properly.
or disposed of properly.
COMPLIANCE INFORMATION
FCC Part 15 Information
This device complies with part 15 of the FCC
rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) This device must
accept any interference received, including
interference that may cause undesired operation.
Privacy of communications may not be ensured
when using this phone.
rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) This device must
accept any interference received, including
interference that may cause undesired operation.
Privacy of communications may not be ensured
when using this phone.
FCC PART 15.105(b): Note: This equipment
has been tested and found to comply with the
limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
has been tested and found to comply with the
limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
technician for help.
FCC RF Exposure Information
This product complies with FCC radiation
exposure limits under the following conditions:
exposure limits under the following conditions:
The base must be placed to allow a minimum of
20 cm (8 inches) between the antenna and all
persons during normal operation.
20 cm (8 inches) between the antenna and all
persons during normal operation.
The base must not be collocated or operated in
conjunction with any other antenna or
transmitter.
conjunction with any other antenna or
transmitter.
The handset is designed for body-worn
operation and meets FCC RF exposure
guidelines when used with any belt clip, carrying
case, or other accessory supplied with this
product. (All necessary accessories are included
in the package; any additional or optional
accessories are not required for compliance with
the guidelines.) Third party accessories (unless
approved by the manufacturer) should be
avoided as these might not comply with FCC RF
exposure guidelines.
operation and meets FCC RF exposure
guidelines when used with any belt clip, carrying
case, or other accessory supplied with this
product. (All necessary accessories are included
in the package; any additional or optional
accessories are not required for compliance with
the guidelines.) Third party accessories (unless
approved by the manufacturer) should be
avoided as these might not comply with FCC RF
exposure guidelines.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: This equipment meets the applicable
Industry Canada Terminal Equipment Technical
Specifications. This is confirmed by the
registration number. The abbreviation IC before
the registration number signifies that registration
was performed based on a Declaration of
Conformity indicating that Industry Canada
technical specifications were met. It does not
imply that Industry Canada approved the
equipment.
NOTICE: This equipment meets the applicable
Industry Canada Terminal Equipment Technical
Specifications. This is confirmed by the
registration number. The abbreviation IC before
the registration number signifies that registration
was performed based on a Declaration of
Conformity indicating that Industry Canada
technical specifications were met. It does not
imply that Industry Canada approved the
equipment.
Radio equipment
The term IC before the radio certification
number only signifies that Industry Canada
technical specifications were met. Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device. "Privacy of communications may
not be ensured when using this telephone".
The term IC before the radio certification
number only signifies that Industry Canada
technical specifications were met. Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device. "Privacy of communications may
not be ensured when using this telephone".
Environmental Requirements
Only use the cordless telephone in
temperatures between -10 ºC to +50 ºC
(+14 ºF to +122 ºF).
temperatures between -10 ºC to +50 ºC
(+14 ºF to +122 ºF).
Avoid exposing the cordless telephone to
direct sunlight or close to other heat
sources.
direct sunlight or close to other heat
sources.
Do not expose the cordless telephone to
open flame.
open flame.
Keep the cordless telephone away from
excessive heat and moisture.
excessive heat and moisture.
Avoid sudden temperature changes to
prevent condensation in the cordless
telephone. It is recommended to put the
cordless telephone into an air tight plastic
bag until the temperature is adjusted, for
example, when entering or leaving a
cold/heated building on a warm/cold day.
prevent condensation in the cordless
telephone. It is recommended to put the
cordless telephone into an air tight plastic
bag until the temperature is adjusted, for
example, when entering or leaving a
cold/heated building on a warm/cold day.
Protect your cordless telephone from
aggressive liquids and vapors.
aggressive liquids and vapors.
If the cordless telephone has been
exposed to water or condensation, remove
the battery immediately and let it dry
completely before re-inserting the battery.
exposed to water or condensation, remove
the battery immediately and let it dry
completely before re-inserting the battery.
Keep the cordless telephone away from
strong electromagnetic fields.
strong electromagnetic fields.
Do not place a cold cordless telephone in
a charger.
a charger.