Honeywell International Inc. 9PGTPA-100A Benutzerhandbuch
Page 2055
1 Dec 2003
34-45-4
7
MAINTENANCE MANUAL
CAS-100 COLLISION AVOIDANCE SYSTEM
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
(2) Reinstall
(a) Reconnect the cable connector (and pneumatic tube, if applicable) to aft of the unit.
(b) Carefully re-insert the unit into the cockpit panel.
(c) Tighten the clamp fasteners on the front of unit.
(d) Do the leakage test of the static line.
(e) Make sure that the unit is tight and check that the rear cable is not twisted or kinked.
D. Dedicated TCAS Traffic Display
(1) Removal
(a) Loosen Dzus fasteners on the front of unit.
(b) Pull the unit forward from the cockpit panel and disconnect the mating cable
connector from aft of unit.
(2) Reinstall
(a) Reconnect the cable connector to aft of unit.
(b) Carefully re-insert unit into cockpit panel.
(c) Tighten Dzus fasteners on the front of unit.
(d) Make sure that unit is tight and check that rear cable is not twisted or kinked.
E. TRA-67 ATC Mode S Transponder System Component
(1) Removal and Reinstallation
(a) Refer to TRA-67 ATC Mode S Transponder System Maintenance Manual, I.B. 1167.
F. Omni Antenna
(1) Removal and Reinstallation
(a) Refer to antenna manufacturer documentation.