OSIM INTERNATIONAL LTD OS-868 Benutzerhandbuch

Seite von 5
 
 
Bluetooth 4.0 Low Energy Module
 
 
 
 
 
 
 
 
 
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt 
RSS standard(s). Operation is subject to the following two conditions: (1) this device 
may not cause harmful interference, and (2) this device must accept any interference 
received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux 
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions 
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de 
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est 
susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party 
responsible for compliance could void the user's authority to operate the 
equipment.
This equipment has been tested and found to comply with the limits for 
a Class B digital device, pursuant to part 15 of the FCC Rules. These 
limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates 
uses and can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful interference 
to radio communications. However, there is no guarantee that interference 
will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged 
to try to correct the interference by one or more of the following 
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that 
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device is intended for OEM integrators only. Please see the full grant of 
equipment document for restrictions.
If the FCC ID of this module is not visible when it is installed inside another device, 
then the outside of the device into which the module is installed must be label with 
"Contains FCC ID:ARG-OS-868 and IC:10142A-OS868".