Nokia of America Corporation BBTRX-06 Benutzerhandbuch
Transport and mount the RRH
Overview
This topic describes how to attach a two-leg lifting sling to the RRH and to move it near
to its designated position using a lifting mechanism such as a derrick.
to its designated position using a lifting mechanism such as a derrick.
Unpack the RRH
Use the following steps to unpack the RRH.
...................................................................................................................................................................................................
1
Make note of the "TIP N TELL" indicator on the package to see if the RRH was
mishandled or tipped during shipment.
mishandled or tipped during shipment.
...................................................................................................................................................................................................
2
Remove the bubble wrap.
Important! Keep RRH upright.
...................................................................................................................................................................................................
3
Check RRHs for signs of damage.
...................................................................................................................................................................................................
4
Report damage as required.
Prepare RRH for lifting and transport
A lifting device or hoisting mechanism is required when moving the RRH.
Obtain M10 eyebolts, lifting device, and mounting hardware.
Lifting harness requirements, when required
The general requirements for a lifting harness are as follows:
• Two-leg sling
• Without shortening element
• Length: greater than or equal to 305 mm (12 inch) from hook to lifting point
• Angle should not be greater than 45 degrees from y-axis
• Sufficient lifting capacity for the RRH including the pallet.
• Two-leg sling
• Without shortening element
• Length: greater than or equal to 305 mm (12 inch) from hook to lifting point
• Angle should not be greater than 45 degrees from y-axis
• Sufficient lifting capacity for the RRH including the pallet.
Transport, mount, and ground the RRH
Pre-installation instructions
Pre-installation instructions
Transport and mount the RRH
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
FDD RRH 700L
3MN-00075-0002-RJZZA
Issue 0
FDD RRH 700L
3MN-00075-0002-RJZZA
Issue 0
September 2012
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
5-3